Where is the fuel filter located on a Jeep Grand Cherokee?
Jeep Cherokee (1984-2001); Grand Cherokee (1993-2004): nut/bolt sizes may vary, but the removal process is similar. Pull Tip: On later model Cherokee there is no replaceable fuel filter. The fuel filter resides in the pump and is suppose to last the lifetime of the pump.
Where is the fuel filter located on a car?
Fuel filter/fuel pressure regulator is mounted in gasket on top of fuel pump module. Fuel pump module is located on top of fuel tank. See Fig. 28 . 2. Manufacturer recommends removing fuel tank for access to fuel filter/fuel pressure regulator.
How do you remove a fuel tank from a jeep?
Remove the electrical connectors by pinching the clips and pulling the connectors apart. Do the same with the quick connector fuel lines. Drop the tank hallway down. If needed remove the hose clamps to release the tank from the filler lines to be able to pull the tank all the way out.
How to install a fuel filter on a fuel pump?
Install NEW gasket on fuel pump module. Install fuel filter/fuel pressure regulator into fuel pump module until it snaps into position. Rotate fuel filter/fuel pressure regulator to install fuel supply line. Install fuel supply line. 2. Install NEW retainer clamp. To install, remaining components, reverse removal procedure.
Where is the fuel filter located on a wrangler?
FUEL FILTER/FUEL PRESSURE REGULATOR Removal (Cherokee & Wrangler) 1. Fuel filter/fuel pressure regulator is mounted in gasket on top of fuel pump module. Fuel pump module is located on top of fuel tank. See Fig. 28 .
Install NEW gasket on fuel pump module. Install fuel filter/fuel pressure regulator into fuel pump module until it snaps into position. Rotate fuel filter/fuel pressure regulator to install fuel supply line. Install fuel supply line. 2. Install NEW retainer clamp. To install, remaining components, reverse removal procedure.
How is a charcoal canister attached to a Jeep Grand Cherokee?
On the Jeep Grand Cherokee, it is mounted to the vehicle with multiple brackets and connected through hoses. This procedure may vary depending on the vehicle’s exact year. Raise the vehicle’s rear end using a floor jack and support it on jack stands.
How do you remove a fuel tank sender?
Drop the tank hallway down. If needed remove the hose clamps to release the tank from the filler lines to be able to pull the tank all the way out. TIP – Those hose clamps are hard to reach so if you want you can just remove the sending unit from here.
How to test fuel pump in Jeep Cherokee?
Use a circuit tester and test the harness side for power as your helper turns the key on and off. Remember that there will be power for only 2 seconds, so have your helper cycle the key on and off as you check the terminals, allowing 5 seconds between cycling for the computer to reset.
Jeep Cherokee (1984-2001); Grand Cherokee (1993-2004): nut/bolt sizes may vary, but the removal process is similar. Pull Tip: On later model Cherokee there is no replaceable fuel filter. The fuel filter resides in the pump and is suppose to last the lifetime of the pump.
Remove the electrical connectors by pinching the clips and pulling the connectors apart. Do the same with the quick connector fuel lines. Drop the tank hallway down. If needed remove the hose clamps to release the tank from the filler lines to be able to pull the tank all the way out.
What to do if your Jeep Cherokee stops running?
If the Jeep Cherokee has stopped running or will not start and you feel that the fuel pump has failed, then this is the proper way of diagnosing the problem before replacing an item that may not be needed. Starting from the basics, take off the fuel cap and listen closely for the fuel pump to come on as a helper turns on the ignition key.