Where is the TPS sensor located on a Jeep Wrangler?
The TPS is held in place by two torx screws and is connected to the vehicles computer by a cream colored modular plug. It is located on the top of the engine next to the air intake.
When to replace a throttle position sensor on a Jeep Wrangler?
If at all possible, I try to do all required minor repairs to any of our out of warranty vehicles. In this case it’s our 2003 Jeep Wrangler TJ. P0122 – Set Condition: Throttle Position Sensor voltage at the PCM is lower than 0.1 of a volt for 1.3 seconds. This is a pretty straight forward replacement.
Can a gas pedal sensor be replaced on a jeep?
He grinned and said that when my Jeep was in for the 10 days, he did replace the gas pedal assembly including the pedal sensor. He said that he would talk to Chrysler engineering tomorrow so they can come up with a new game plan. The Jeep continues to run perfectly, this is just an annoyance.
Where is the TPMS receiver on a Jeep Wrangler?
The Jeep Wrangler TPMS wireless receiver is located on the chassis cross member. The receiver gets its information from dual-axis accelerometer in the wheel sensors. This is used to determine front and rear position through its signal strength.
How does the tire pressure sensor work on a Jeep Wrangler?
The WCM (Wireless Control Module) receives the info from the sensors, which is then relayed to the driver onboard. The alert warning on the dashboard cluster will remain eliminated until the tire is inflated to the placard pressure. All this information is processed within seconds of the vehicle driving and all done automatically.
If at all possible, I try to do all required minor repairs to any of our out of warranty vehicles. In this case it’s our 2003 Jeep Wrangler TJ. P0122 – Set Condition: Throttle Position Sensor voltage at the PCM is lower than 0.1 of a volt for 1.3 seconds. This is a pretty straight forward replacement.
He grinned and said that when my Jeep was in for the 10 days, he did replace the gas pedal assembly including the pedal sensor. He said that he would talk to Chrysler engineering tomorrow so they can come up with a new game plan. The Jeep continues to run perfectly, this is just an annoyance.
Where is the TPS located on a Jeep Wrangler?
The TPS is held in place by two torx screws and is connected to the vehicles computer by a cream colored modular plug. It is located on the top of the engine next to the air intake. Remove the modular plug before removing the 2 screws on the TPS.
What’s the problem with the throttle on a jeep?
I went back and they said that the throttle position sensor faulty and the entire throttle body needed to be replaced. So, they ordered one and installed it. They then told me that when they tested it, the computer said that it was only at 75% throttle when they were in fact giving it full throttle.