How do you mount a fog light on a dash?
Mount the switch on the bottom of the dash or any convenient place. Cut one length of the 10-gauge wire to reach from the battery positive terminal to the relay and two lengths of 16-gauge wire to reach from the relay to the switch. Cut another length of 10-gauge wire to reach the fog lights.
How to wire fog lights and driving lights?
For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead.
How to install fog lights on a grill?
1 Bumper Mount. Bumper mount lights fit in specifically designed holes and are usually round or rectangular. This style is the way that most fog lights come from the factory. 2 Grill Mount. Larger, usually round. These lights are installed on the front grille or mounted directly behind it. 3 Rack Mount. Round or rectangular lights. …
How do you remove a fog light from a car?
Engage the parking brake. Open the hood. Bumper mounted fog lights are typically below the headlights. Check your vehicle manual if you have difficulty locating them. Disconnect the fog light switch from the housing. This disconnects the fog light from the vehicle’s power system. It should disconnect by detaching the clip.
How do you wire fog lights on a car?
A three-way connection must be made joining the second wire from each of the fog lights to the red wire going to the relay terminal “87.” Finally, attach the switch to the dash and the relay to its location. A test is in order before you use the lock ties and button everything up.
Are there any instructions for a fog light kit?
Unfortunately, most fog light kits don’t come with instructions. With just a wiring diagram at best, you’re left with a pile of wires to figure out on your own. This guide should fill in the gaps, but know that the following info applies to most vehicles and adjust accordingly based on your vehicle.
How are the fog lights connected to the ground?
This terminal will carry power to the fog lights. The fog lights each have two wires, one for ground and one for the 12V power. One of these wires from each fog light has already been connected to ground. A three-way connection must be made joining the second wire from each of the fog lights to the red wire going to the relay terminal “87.”
What kind of Fuse do you need for a fog light?
Splice a red wire from the headlight wire to the relay terminal “30.” This line needs a 10-amp inline fuse, so be sure and wire one in. The final terminal on the relay is numbered “87.” This terminal will carry power to the fog lights. The fog lights each have two wires, one for ground and one for the 12V power.