Do you need to replace the clutch on a CJ7?
So if you own a CJ7, the chances are good that you will eventually need to replace the clutch. The transfer case complicates the job, but it is still not too difficult if you take it step by step. Park the Jeep on a flat surface. Set the parking brake and put the transmission in neutral.
When did the last Jeep CJ7 come out?
The average car owner doesn’t keep a car long enough to wear out the clutch, but the same cannot be said for Jeep CJ7 owners. The last CJ7 rolled off the assembly line in 1986, and owners tend to keep them for a long time.
When was the last time a CJ7 rolled off the assembly line?
The last CJ7 rolled off the assembly line in 1986, and owners tend to keep them for a long time. So if you own a CJ7, the chances are good that you will eventually need to replace the clutch.
How do you change the transmission on a jeep?
Park the Jeep on a flat surface. Set the parking brake and put the transmission in neutral. Remove the screws that hold the transmission cover to the floor. Pry the cover up slightly so it is able to move freely. Position the floor jack under the rear of the transmission and raise the jack until it makes solid contact.
So if you own a CJ7, the chances are good that you will eventually need to replace the clutch. The transfer case complicates the job, but it is still not too difficult if you take it step by step. Park the Jeep on a flat surface. Set the parking brake and put the transmission in neutral.
The average car owner doesn’t keep a car long enough to wear out the clutch, but the same cannot be said for Jeep CJ7 owners. The last CJ7 rolled off the assembly line in 1986, and owners tend to keep them for a long time.
The last CJ7 rolled off the assembly line in 1986, and owners tend to keep them for a long time. So if you own a CJ7, the chances are good that you will eventually need to replace the clutch.
How do you change the clutch on a car?
Remove the old pressure plate and clutch disk. Reach into the recess in the center of the flywheel and pull the old pilot bushing out. Clean the flywheel with brake cleaner. Put a dab of grease on the new pilot bushing and insert it in its recess. Place the new clutch disk against the flywheel and place the new pressure plate against it.