What is the condition of my Jeep Liberty?
When the key is turned to the “Start” there is absolutely nothing. No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4.
Why does my Jeep Liberty engine not start?
There are a lot of issues that can cause your Liberty to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
What to do if your Jeep Liberty has no crank?
4. Tried Neutral safety switch by moving through from Park to Neutral while turning ignition – No change. 5. Tried both keys. 6. When Key is in the “On” position.
Are there skim keys on a Jeep Liberty?
One interesting thing is that the Security LED on the dash is lit during all of this. Also, the Jeep doesn’t use the SKIM system for the keys/ignition. Mine are just the normal black (Non SKIM) keys, One interesting thing is that the Security LED on the dash is lit during all of this.
What happens if you misfire a Jeep Liberty?
The P0306 trouble code will trigger the Liberty’s service engine soon light. The vehicle itself may begin to run rough. It depends on how serious the misfire is. The vehicle may produce excess vibration, especially at lower RPM. Fuel mileage may suffer. You may smell raw gas coming from the tailpipe.
Are there any problems with the Jeep Liberty 3.7 engine?
According to one leading engine builder, Chrysler’s 3.7-liter engine has some fatal flaws. The engine builder also adds that if not attended to, there could be some serious as well as catastrophic vehicle failures just after the warranty expires.
Where is cylinder 6 on a Jeep Liberty?
An important thing to understand when finding the location of Cylinder 6 is that it’s going to be the sixth cylinder in the firing order. It won’t be the sixth cylinder that you might see when looking at the engine. The P0306 trouble code will trigger the Liberty’s service engine soon light. The vehicle itself may begin to run rough.
Why is my engine not working on my Jeep Liberty?
Reports indicate that the original Chrysler engine design has valve seats that are pressed into the cylinder heads. The issue comes about when the powdered metal the valve seats are constructed of- enlarges or expands. This causes a drop into contact with the valve as well as the Jeep’s pistons.
Why does my Jeep Liberty turn over but not start?
When attempting to start the engine, it turns over normally but will not start. The engine does not even attempt to start. Found the problem, a mouse had chewed through a wire located near the ECU. The ECU is located on the fender by the right side hood hinge.
Where is the ECU on a Jeep Liberty?
The ECU is located on the fender by the right side hood hinge. Spliced the wire and wallah it starts and runs normally!!!! Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
What was the problem with my 06 Liberty?
My 06 liberty was running fine it seemed ! It been running 30 minutes with no problem.it sat idling while i put the fam in the car,and we started driving.about a half mile away i came to a stop sign,when i went to take off,it choked bad but then it caugh n was still running and i went ! 2 blocks later ? It stalled !
Can you change the engine on a Jeep Liberty?
Two of the tricks is the power steering and ac compressor can be left attached and just pushed aside. Probably the same trick for a lot of jeeps. Just about any vehicle needing a engine is going to be costly unless it’s ubiquitous like a 4.0 . I found the 3.7 a hard engine to find a good cheap one.
When did the Jeep Liberty KJ come out?
There are two versions of the Liberty. The KJ series which was produced from 2002 to 2004, and the KK series introduced in 2005 to the present. There are four wheel drive models and two wheel drive models.
What kind of transmission does a Jeep Liberty have?
There are two versions of the Liberty. The KJ series which was produced from 2002 to 2004, and the KK series introduced in 2005 to the present. There are four wheel drive models and two wheel drive models. Two types of transmissions are available for the Jeep Liberty, a five speed manual transmission, and a 4 speed automatic.
Can a 2012 Jeep Liberty be swapped to a 06?
When i swapped the 2012 in to the 06, it was very straight forward and a low mileage engine to, skipped a ton of steps like the rear main seal and crank seal because they were still perfect at 30k mikes and three years old at the time I bought it.
What should I do if my Jeep won’t start?
The normal sequence would be: start and run for 10 seconds, then quit, if someone tries to use an unauthorized key. It will allow you to do this three times before it shuts down completely. Anti-theft! If you have a second key, try try it and see if the problem goes away. If so, you will need to get the first key reprogrammed.