When does a service start and when does it stop?
Automatic (Delayed Start) – With a service in this state, it will start just after boot time. Some services, when no longer required, will also automatically stop when not needed. If you find you do not need a service, place it into Manual or Disabled.
Can you stop services that are configured to start automatically?
It is especially important to use caution when changing the Startup typesetting of services that are configured to start automatically. Some services, such asRemote Procedure Call (RPC), Event Log, and Plug and Play, cannot be stopped by using the Servicessnap-in window or the net stopcommand.
How to start, stop, and disable services in command prompt?
To Start, Stop, and Disable Services using Sc Command 1 Open an elevated command prompt, and do step 2 (stop), step 3 (disable), step 4 (enable), or step 5 (start) below for what you would like to do. 2. To Stop a Service using “Sc Stop” Command in Command Prompt
What happens when I change default service settings?
Starting a service does not automatically restart its dependent services. Changing the default service settings may prevent key services from running correctly. It is especially important to use caution when changing the Startup type setting of services that are configured to start automatically.
How can I get my phone out of emergency mode?
The first thing to try as it’s often the best solution to get your phone out of the Emergency Mode is to perform a battery pull on the device. Pull out the battery for about 30 sec to a minute and then re-insert the battery and then power the phone back on.
How to clear the perform user maintenance message?
After you install the maintenance kit, you can clear the PERFORM USER MAINTENANCE message by going to the printers control panel Configuration Menu and setting the SERVICE MESSAGE = to OFF. Note: this message will only appear in the Configuration Menu if the PERFORM USER MAINTENANCE message appears.
How to get rid of the maintenance message on a printer?
We recommend the following procedure to manually set the maintenance count to zero. 1. Enter service mode. 2. Go to the MAINTCOUNT screen and press + or – to scroll the number to zero (all zeros). 3. Press the Select button to enter the settings into the printers memory (an asterisk will appear next to the zeros). 4.