What type of oil does a 2013 Jeep Wrangler take?
5W-20 motor oil
Per Owner’s Manual the 3.6L Pentastar engine in the 2013 JK takes 6 quarts of 5W-20 motor oil. Experience put the fill at just a little under this (about 5.6 quarts). Perhaps 0.4 quart is retained during the change. Jeep recommends an oil that meets or exceeds MS-6395 certification.
How much oil does a 2013 Jeep Wrangler take?
5.9 quarts (with filter)After refill check oil level.
What kind of oil does a 2013 Jeep Wrangler take?
Gather the Needed Supplies. Per Owner’s Manual the 3.6L Pentastar engine in the 2013 JK takes 6 quarts of 5W-20 motor oil. Experience put the fill at just a little under this (about 5.6 quarts). Perhaps 0.4 quart is retained during the change. Jeep recommends an oil that meets or exceeds MS-6395 certification.
Is it OK to use synthetic oil in a Jeep Wrangler?
The owner’s manual does not specify conventional or synthetic oil for the engine. One thing for sure is, there has never been an engine that has failed directly as a result of using regular oil, blend or synthetic oil. So before you select which oil type to use, there are a few important factors to take into consideration.
How often should I change the oil in my Jeep Wrangler?
A smooth reliable engine isn’t the result of premium fully synthetic engine oils changed at 10,000 mile intervals, but rather the regular changing of the oil and filter at recommended intervals. 4-Wheel drives and off-road driving techniques has been my passion for over 20 years.
Where is the oil filter on a JK Wrangler?
Replace Filter. The oil filter on the 3.6L Pentastar (Wrangler 2012/2013) is located on top of the engine just behind the alternator. Unlike prior models which used a can type filter that was spun on, the JK uses a paper media filter that is installed into a chamber attached to the engine.
How much oil does a Jeep Wrangler take?
Jeep Wrangler JK Fluid Capacities Component Quantity Fluid Type 3.8L Engine Oil 6 Quarts / 5.7 Liters 5w-20 3.6L Engine Oil 6 Quarts / 5.6 Liters 5w-20 Brake Fluid Fill to Full Mark DOT 3 Clutch Fluid Fill to Full Mark DOT 3
What does W mean on a Jeep Wrangler oil rating?
The “w” in the viscosity indicates the oil’s viscosity in winter temperatures. Generally, a faster flowing oil in colder temperatures is desirable because this means more internals get oil at startup faster than a slower flowing oil, reducing wear and tear on your engine. In terms of gear oil, you’ll see ratings like GL-3 and GL-4.
Can you use GL-3 fluid in a Jeep Wrangler?
If it’s a GL-4 bottle without the GL-3 rating, don’t use it in a transmission calling for GL-3. ATF+4 and ATF+3, on the other hand, are significantly simpler. ATF+4 was developed to succeed ATF+3 applications and degrade much slower.
How many liters does a Jeep Wrangler have?
Jeep Wrangler JK Fluid Capacities Component Quantity Fluid Type Dana 30 Axle 2.1 Pints / 1.0 Liters 80w-90 Dana 35 Axle 3.5 Pints / 1.7 Liters 80w-90 Dana 44 Front Axle 2.7L / 1.3 Liters 80w-90 Dana 44 Rear Axle * 4.75 Pints / 2.25 Liters 80w-90