Can you use LED headlamps with LED fog lights?
BS, what I did was install just the LED Fog lights and bought good quality bulbs for the headlights. It works real good, you can use some of after market Blue tinted headlight bulbs to match the color of the LED fogs if you want. But the LED fog lights kick but.
Why does my Jeep Wrangler stereo go weak with fog lights on?
Headlights on/off makes no change , but fog lights on/off makes weak station go from stereo to mono and not worth trying to listen to. Can the antenna cable be shielded to avoid this interference? Another interesting fact. My wife’s 2015 Sahara with factory stereo and LED fogs are not affected by the on/off signal strength.
Why are my fog lights not working after installing LEDs?
When I 1st installed them, my foglights would not work and only the high beam side of the headlights was working. I cured the problem by connecting one of the halogen bulbs in parallel with one of the LED lamps. This adds some resistance to the circuit and everything works perfectly now.
Is the LED fog on my Sahara bad?
My wife’s 2015 Sahara with factory stereo and LED fogs are not affected by the on/off signal strength. But very noticeable on other 2015 with a Kenwood stereo. Any ideas?
BS, what I did was install just the LED Fog lights and bought good quality bulbs for the headlights. It works real good, you can use some of after market Blue tinted headlight bulbs to match the color of the LED fogs if you want. But the LED fog lights kick but.
What makes the fog lamp go off when the parking lights go off?
This includes a power supply wire for the fog lamp switch, the dash lamp dimmer switch, and the map light switch, so those lamps will go off when the parking lights are switched off.
Where does the fog light get its power from?
The fog light switch gets power from the parking light terminal on the headlight switch. Then there is a single continuous red/yellow wire from the “F” switch all the way to the fog light connector.
What are the wires for the parking lights?
All parking light power wires are red wires starting from the headlight switch. This includes a power supply wire for the fog lamp switch, the dash lamp dimmer switch, and the map light switch, so those lamps will go off when the parking lights are switched off.
This includes a power supply wire for the fog lamp switch, the dash lamp dimmer switch, and the map light switch, so those lamps will go off when the parking lights are switched off.
The fog light switch gets power from the parking light terminal on the headlight switch. Then there is a single continuous red/yellow wire from the “F” switch all the way to the fog light connector.
Is it possible to wire into existing fog lights?
In line with the above, fogs would put a huge extra load and strain on the low beam circuit and not only blow a fuse but mess up the buss at which point you are screwed. The wiring would also now be very underrated and this is asking for a fire. Using a relay switch is the ONLY way I could recommend installing foggies…..
All parking light power wires are red wires starting from the headlight switch. This includes a power supply wire for the fog lamp switch, the dash lamp dimmer switch, and the map light switch, so those lamps will go off when the parking lights are switched off.