How to do a reset on a Jeep Wrangler?
1 Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds. (This is to discharge the PCM capacitors, which maintain the Adaptive Memory. 2 Reconnect the Battery Cable 3 Turn Ignition Switch to the “ON” position but DO NOT start the engine 4 Turn Headlight “ON” 5 Turn Headlights “OFF” 6 Turn Ignition Key “OFF”
How to troubleshoot a no start Jeep 4.0L?
More specifically, this means that troubleshooting the problem requires that you check and confirm that: All 6 cylinders are getting spark (with a spark tester). That the fuel pump is creating enough fuel pressure. And if necessary, check the engine’s health with a compression test. I’ll go into more specific details in the following headings: 1.)
What to do if your scanner won’t read?
Use your voltmeter to read from pin 16 to a good ground near the connector. If batt voltage is read – okay. Next, go from pin 16 to pin 4 (ground for the scanner) If batt voltage is read – okay. Repeat using pin 5 as ground.
Why does my Jeep turn over but does not start?
Cranks But Does Not Start Condition: In this type of condition, you turn the key and the engine in your Jeep cranks (turns over) but it doesn’t start (run). The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc.
More specifically, this means that troubleshooting the problem requires that you check and confirm that: All 6 cylinders are getting spark (with a spark tester). That the fuel pump is creating enough fuel pressure. And if necessary, check the engine’s health with a compression test. I’ll go into more specific details in the following headings: 1.)
Cranks But Does Not Start Condition: In this type of condition, you turn the key and the engine in your Jeep cranks (turns over) but it doesn’t start (run). The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc.
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
What is the ignition system on a jeep?
The ignition system is the one tasked with creating and delivering spark to each of the 6 cylinders. Without spark, the engine will crank but Not Start. The ignition system of the Jeep vehicles covered by this tutorial use either a distributor type system or a COP (Coil-on-Plug) ignition coil system.