How do you turn off the check engine light on a 2008 Jeep Patriot?
The firSTStep is to open Your door on the driver’s side, and get in. Next, turn the ignition to the “on” or “run” position. You will need to do this a total of 3 times. Now, start Your engine, and the check engine light should be gone from Your dashboard.
How do you turn off the check engine light on a Jeep Patriot?
You can find out the trouble code causing Your problem by inserting the key into the ignition and turning it to the on position. Next, make sure the trip display is showing the trip mileage. Now hold the trip reset button for about 10 seconds. After the time has expired, cycle the ignition off and on three times.
What are the warning lights on a 2008 Jeep Patriot?
Warning lights ABS, 4WD, ESP,and TRACTION CONTROL all came on at one time. I just took my 2008 Jeep Patriot in the dealership TODAY for this. The lights have been on for a while but I finally took it in, assuming it was a sensor or something. WOW!!!! They said it would be over $1,000 for the repair and it was a ABS Pump and Module system.
How do you reset the ECM on a jeep?
The following sequence is used to reset the ECM or PCM as it is sometimes refered too. 1. Disconnect the battery by removing the Negative battery cable (This will ensure that any possibility of grounding the power side to the vehicle [or yourself – think wedding ring] does not happen.) 2. Disconnect the Positive battery cable 3.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
Where are the warning lights on a Jeep Compass?
I am currently experiencing this exact problem with my 07 Jeep Compass. Thanks! It’s connected to the body near the battery. It’s bolted to the frame above the drivers side headlamp. You’ll know it when you see it because the other end is attached to one of the battery terminals.