How to fix no bus on jeep?
What does this mean and how can I fix it? Loose connection behind the dash cluster. Remove the cluster and clean all connections with dielectric grease. Firmly reconnect everything.
How do you reset the codes on a 2004 Jeep Wrangler?
How to Clear Codes on Jeep Wrangler
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
Is there a way to fix no bus no gauges?
No Way Not three times with it working fine for months in between. Cut to the chase. The Connector to the PCM wiring harness at the PDC was loose! Its the one that has a bolt in the middle of a square white connector. As I started to unscrewed it I noticed that the bolt was not tight. Ah ha!
What kind of truck has no bus gauges?
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!
Why does my Dodge truck have no gauges?
Fortunately when I finally broke down out of utter frustration and took it to the dealer to have it repaired the first time it didn’t cost me an arm. $108 later the service guy said it was a loose wire connection in the PDC.
What does no bus mean on a jeep?
The reply stating that the battery was just changed makes me more suspicious that this is the cause. The no bus syndrome on the jeeps. Had one in the shop a no start with the fuel and amp gauge not working. The no bus signal on the odom.
Why is my airbag light not working on my Jeep Wrangler?
This condition is caused by minor oxidation of the BUS circuit terminals at the instrument cluster connector. Electrical terminals will show signs of oxidation, which will appear as darkened lines or marks on the cluster male terminals.
What does the no bus sign on my car mean?
Pcm depends on an 8 volt ref to communicate through the bus line to the cluster to operate the dash and to communicate threw the aldl connecter. If any sensor shorts out the pcm goes dead and the no bus sign shows. On the rear drivers side top of bellhousing is the location for the crank sensor. Unplug the sensor and watch your dash.
What does no bus mean on the odometer?
RECENTLY HAD “no buS” SHOW ON THE ODOMETER IN MY 2000 JEEP WRANGLER. THE VEHICLE DID START AND RAN WITHOUT A PROBLEM, BUT WHO KNOWS FOR HOW LONG. THE ONLY RECENT CHANGE WAS A NEW BATTERY. Having the same problem on my ’99 Jeep Cherokee.