Where is the idle air passage on a jeep?
Hi Nuttyjeep, when you remove the resonator box from the throttle body, you can see the idle air passage on the lower side of the throttle body just below the throttle blade. When you remove the IAC motor (again), you can clean the air passage on both sides from the control opening.
Are there any idle problems in my Jeep?
Drove car about 25 miles got on expressway took it to about 75 car ran great no idle problems at all. Got home and did the key thing to get code, and got, p0601 again, disconnected battery to clear code and it did but did the up and down again leveled out again but check engine light back on again.
What to do about rough idle on 4.7 HO engine?
When you remove the IAC motor (again), you can clean the air passage on both sides from the control opening. Or you just spray a special throttle body cleaner into it with the engine running.
How many miles on a 2004 Ford WJ 4.0?
Hoping someone can give some advise, just got 2004 wj 4.0. It has 12100 miles on it. As I was driving home from where I bought it, the check engine light came on, stop and had code read.The code was 601 everything on the car worked great.
What is the idle air control on a Jeep Cherokee?
Cherokee’s no-limits power delivers precision on the highway and power on the trail, but a capable engine requires the right amount of air. A Jeep Cherokee idle air control valve from AutoZone closely monitors your engine’s air intake and optimizes your ride wherever you drive.
Why do you need an IAC valve on a Jeep Cherokee?
A high-quality Cherokee IAC valve eliminates any existing dirt clogs and prevents your engine from taking in too much fuel. A proper air-fuel ratio keeps your RPM from dropping and your Jeep from backfiring, and an engine that breathes easier lasts longer, too.
What does an idle air control valve do?
A Jeep Cherokee idle air control valve from AutoZone closely monitors your engine’s air intake and optimizes your ride wherever you drive. Our aftermarket idle air control valve for Jeep Cherokee improves your response time by closely monitoring the amount of air entering your engine.
What does rough idle mean on a jeep?
While the Jeep was stopped and idling, for example at the stoplight, we both noticed the engine idling rough, like it wanted to stall out, with the RPM fluctuating between 400-500 RPM (it did dip to as low as 350 on a couple of occassions). No trouble codes were displayed, however.
What should the TPS be at idle on a jeep?
A faulty IAC would give a constant idle (high or low) and a fault code for the IAC. Erratic is normally the TPS. If you have a scanner which shows live data, you can see the TPS % going up and down a bit. Its normally around 12 % at idle.
Can a bad throttle position sensor cause idle surging?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light
What causes the Check Engine light to turn off at idle?
At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. The check engine light will randomly turn on and off even if the car is running smoothly without any jerks and stalling.
Hi Nuttyjeep, when you remove the resonator box from the throttle body, you can see the idle air passage on the lower side of the throttle body just below the throttle blade. When you remove the IAC motor (again), you can clean the air passage on both sides from the control opening.
While the Jeep was stopped and idling, for example at the stoplight, we both noticed the engine idling rough, like it wanted to stall out, with the RPM fluctuating between 400-500 RPM (it did dip to as low as 350 on a couple of occassions). No trouble codes were displayed, however.
What causes a rough idle on a 4.7 Ho?
He also mentioned that bad O2 sensors can cause a rough idle, but he said bad O2 sensors would not cause the engine to idle as roughly as it did. He also noted that he had to clean the injectors while the top end was apart since there were gummy deposits on them. FYI, all the injectors and both fuels rails were replaced last December.
How to reset throttle body calibration [ step by step guide ]?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
Can a throttle actuator be used as an IAC valve?
It should be noted that that most cars made within the past decade or so don’t have an IAC valve. Instead, they use an electronic throttle actuator for the same purpose. If you suspect your IAC valve is malfunctioning, have your mechanic inspect your car.
Where is the IAC valve on an engine?
It accomplishes this by controlling the amount of air that gets around the throttle plate and enters the engine. Typically, the IAC valve is mounted on the throttle body, which is seen in the diagram. The engine’s computer controls the valve by sending voltage pulses to it.
What are symptoms of failing Idle Air Control ( IAC ) valve?
Symptoms of a failing idle air control valve. A faulty idle air control (IAC) valve can cause a number of problems with your vehicle: 1. Incorrect idle speed: An IAC valve that sticks in the closed position will create an idle speed that’s too low.
Can a faulty IAC valve cause a car to stall?
The car stalls: A faulty IAC valve can prevent the engine from getting enough air to idle properly. As a result, the car may stall. 4. The car won’t start: In extreme cases, the IAC valve may cause too much or too little air from entering the engine when you turn the ignition, resulting in engine that cranks but doesn’t start.