Why does my Jeep WK2 run at 1300 rpm?

I just had to adjust the way I drive it at certain times. It mainly did it going up hill or at around 40 mph at 1300 rpms. Just like the WK2 guys with the 3.6 engine. They are experiencing something similar with having to adjust the way they drive due to lack if power and not so good tuning.

How often does Jeep Cherokee engine shut down while driving?

Now it’s been about five months and this week the car has decided to stop running while in motion. It has happened four times, this happens on turns or while accelerating/decelerating at stops and freeways. 50% of the time the check engine light comes on, only to turn off once back in motion. It’s becoming dangerous.

What’s the gas mileage on a Jeep Wrangler?

JLUR, auto, stock tires with stock 4.10 gears, hard top. Some of that time (probably 90 miles) were on 315-70/17 with tuner adjusted speedo. I think that is pretty darn good for a brick on wheels. But, i didn’t buy it for it’s stellar fuel consumption.

What’s the problem with my 2015 Jeep latitude?

I’m having the same problem with my 2015 Jeep Cherokee Latitude as everyone else. Driving along, car shuts down. Ignition doesn’t want to start it up again. The more I have to restart my engine, the sooner the ignition will go as well. I am NOT HAPPY! Service Manager said it needs oil checked every time I get in the car. Synthetic oil.

What is the RPM of a Jeep Cherokee?

Problem seems resolved. When coming to a stop and giving it gas the engine’s rpm goes as high as 6000 rpm and slowly rolls into the intersection or on the ramp to interstate. You are a sitting duck for 4 or 5 seconds before the transmission kicks in and squeals the tires and throws your head back.

What’s the problem with my Jeep Cherokee downshifting?

The Jeep is at the dealership now for the 3rd time and has been there for 4 days so they can experience the problem by driving it to lunch and back. They called today and said it never acted up for them when they made a test drive.

How to do high RPM upshift on Jeep Wrangler?

You can plug in your FlashCal or whatever programmer you have and see what settings it has for tire, gear etc. Click to expand… No codes, programming was done by a different dealership for the previous owner who had the 3.5″ AEV lift and 35’s done.

Why does my Jeep Wrangler not accelerate when the RPM goes up?

Here are the most common cause of acceleration with the RPM’s going up: 1. Transmission Fluid Low. If your Wrangler is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.

What’s the highest RPM you can go in a Jeep Wrangler?

I was holding accelerator at maybe 5%, took my foot completely off it at ~5k rpm, it ramped up to ~5100, then took about a second and a half to shift to 3rd. Reminded me of that scene from Dogma – “What gear are you in???”

Why does my Jeep have a pulsing sound?

It also feelsl ike ive been getting less power in higer speeds. The car idles and drives perfectly at slower speeds but on the highway you can really feel the pulses and hear the exact making sounds. The only way to get the pulsing to stop is to give the jeep more gas.

What happens if you leave your Jeep on too long?

If you have consistent high idling in your Jeep, there are some negative consequences, making it important that you identify these issues when they arise: Fuel Waste: Leaving a car on for an excessive amount of time, especially when idling high, will result in fuel loss.

When do you start the car, the engine revs?

Car engine revs way up immediately upon starting engine. Q: Car engine revs way up immediately upon starting engine. When starting the engine, it sounds like you have your foot pressed to the floor on the gas pedal as soon as you start it, without even having your foot on the gas.

When did Jeep start using The 42RE transmission?

Jeep Grand Cherokee started using the 42RE transmission in 1993 1/2 models with the 4.0L engine. The “4” stands for 4-speed, “2” is for torque capacity, “R” is for rear-wheel drive, and “E” is for electronically controlled.

What kind of engine does a jeep 4.6 have?

That’s only for the 4.6 and 5.7 Edit: Let me just say mine is going to buck/surge regardless what I did. I just had to adjust the way I drive it at certain times. It mainly did it going up hill or at around 40 mph at 1300 rpms. Just like the WK2 guys with the 3.6 engine.

Can a 4.6 Stroker be installed in a jeep?

The answer is to install a Golen Engine 4.6L Jeep Stroker engine. With 270hp and 300 ft lbs of torque, it will bring life back to your Jeep and make it fun to drive again!! Facts you need to know about our Jeep 4.6 Stroker: Built to be a direct bolt-in replacement for factory 4.2 or Jeep 4.0 engines from any year

What kind of engine does a Jeep 4.0 have?

Jeep 4.0 crate engines will give you “as-new” performance, but let’s be honest, “as-new” wasn’t that great. Here’s why you should consider one of our Jeep stroker engines.

How big is a 6 cylinder Jeep engine?

Cylinder compression pressure. 120 to 150 psi. Oil pressure. At idle (600 rpm) 13 psi. Above (1600) rpm 37 to 75 psi. Bore diameter. 3.875 to 3.877 inches. Taper and out of round (Maximum) 0.001 inches.

Jeep 4.0 crate engines will give you “as-new” performance, but let’s be honest, “as-new” wasn’t that great. Here’s why you should consider one of our Jeep stroker engines.

What to do if your Jeep won’t start?

With the key in the “start” position, if the starter motor is getting power but the starter doesn’t work, then the starter is condemned and replaced. Note that starters can and do sometimes develop intermittent faults due to bad spots on the armature.

Why does my Jeep make pulses while driving?

Not during the whole acceleration, only when i apply more gas and the rpms rise, usually once i back off it stays steady. It also feelsl ike ive been getting less power in higer speeds. The car idles and drives perfectly at slower speeds but on the highway you can really feel the pulses and hear the exact making sounds.

What happens when there is no power in a jeep?

If there is no power, then the electrical circuit supplying the motor has a fault. That circuit begins at the battery and includes grounds, wiring (some of which is very heavy cabling), fuses, relays, the ignition switch and terminations.

Why does my car jerk at low speeds?

Car jerks when accelerating at low speeds is not something rare. If you have driven a stick shift car before or if your car has a manual transmission, you are sure have experienced the car jerk followed by the engine stalling.

What to do when your car jerks when accelerating?

Below is the steps to practice but you should ask your driving teacher for further understand if needed: Press the clutch pedal down to the floor. Move the stick into first gear and ease onto the gas pedal while at the same time slowly releasing the clutch pedal. Make sure to perform this transition smoothly, or else the car will jerk really fast.

Why does my car Jerk when I slow down?

If the car sat for a year with fuel in the gas tank, that fuel has oxidized and created gum, varnish and other solid contaminants that have plugged up the fuel filter and the fuel injectors. The fuel filter is… After replacing valve cover gaskets, car runs horrible, and throws 5 different codes.

Why does my Jeep have vibration at certain RPMs?

Vibration at certain rpms sounds like a rotational part out of balance or with a worn bearing which in addition to the items already suggested could possibly include underhood, belt driven items.

What causes a car to buck at high speed?

We’re not talking about a knocking engine or one that idles rough or stalls. We’re talking about engines that start easily and accelerate smoothly, but then, after a few minutes at a steady speed, either surge in speed or misfire, causing the car to “buck.”

What should the idle speed be on a Jeep Cherokee?

Compare the idle speed to the specifications on the vehicle emission control information sticker, which is in the engine compartment. Normal idle speed is 700 to 750 rpm.

How many miles does a Jeep Cherokee take to stall?

Jeep Cherokee XJ’s and Cherokee KJ’s with less than 25,000 miles have experienced stalling problems, but most cases seem to involve vehicles with 75,000 miles or more on them, and it is with particular reference to these older vehicles that the PCM is most relevant.

Why does my Jeep Cherokee keep stalling?

While certainly frustrating, these stalls can also have serious consequences. Here is why your Jeep Cherokee keeps stalling: Many stalling problems can be attributed to the PCM or crankshaft sensor and there are steps you can take to fix these issues yourself or at the very least point your mechanic in the right direction

Why does my Jeep Patriot keep bucking while shifting?

They also lubed and adjusted the transmission shift cable. The bucking incidents happen very frequently and feel like several quick studder between shifting. Long story short I’m frustrated without having no vehicle for a month, the investment of several hundred dollars in repairs and no resolution.

Why does my Jeep stutter on a hill?

Mine was stuttering on hills. Not usually from a dead stop, but during acceleration after it was already moving, like getting on an entrance ramp or coming to a hill where it needed more power. It was like the whole engine quite for an RPM or two, then it would smooth out. If it was a long hill it might happen again.

What to do when your Jeep Patriot Bucks?

They can duplicate the problem and have done a driveability upgrade and replaced the transmission valve body. They also lubed and adjusted the transmission shift cable. The bucking incidents happen very frequently and feel like several quick studder between shifting.

Is the vibration gone from my Cherokee SRT8?

So after work today I went on some spirited driving and and finally hit the sweet spot of that Damn 70 mph vibration and surprise the vibration is all gone. I also did some nice rips up to 130 mph and my rig is solid and driving like it never did before.

How many miles does a Jeep SRT8 have?

I also did some nice rips up to 130 mph and my rig is solid and driving like it never did before. What sucks is that I bought this jeep with 6200 miles and at 8000 miles I detected this issue and had to deal with it till now, which I have 28,143 miles now and more then 2 years later.

What kind of vibrations does a Jeep Grand Cherokee have?

Love the Jeep Hate the Vibrations. The low pitched rumbling and vibrations startsat 70 mph, worst at 75mmph, gone by 80mph. Definitely worse when going uphill, when they can start at 60 – 65. The dealer replaced the driveshaft — no change at all. I have a Laredo and I think the wheels are aluminum. Any other ideas?

What’s the problem with my Jeep Grand Cherokee?

When i brought it to the dealership they said the drive shaft was to blame and they replaced the drive shaft. drove home and noticed the same problem once again. Brought it back to the dealer….to make a long story short i have had my jeep in and out of the shop for months and still no solution.

Is the drive shaft on a Jeep Grand Cherokee bad?

I test drove a 2006 dodge charger brand new and the drive shaft was bad it had the same vibration. The guys at the shop could not believe it. I live in Canada but have the same problem with a 2005 Grand Cherokee. Have had drive shaft replaced, wheels balances, tranny rebuilt and various other tests.

Why does my Jeep Cherokee turn off while driving?

IF it just quits while going down the road, or if it starts running rough while at an idle then quits it could be this problem. It will also crank right back up sometimes or it may take 10 minutes or longer. To correct the problem remove the reservoir on the passenger side. The computer mounts to the firewall directly behind the reservoir.

What kind of engine does a Jeep Cherokee have?

I have a 1994 jeep Cherokee sport 4wheel drive. I get up to 35mph and it cuts out spits and spudders and back fires. Iv changed fuel pump, fuel filter, alternator, spark plugs, crank sensors. Iv taken throttle body off and cleaned it and cleaned all sensors as well. Iv done just about everything and still can’t figure it out.

Can a Jeep Cherokee turn off while driving?

I’m having the same thing happen! 1994 Jeep Cherokee, 255,??? miles on it! few days ago sat in a -drive through- idling, (It got up to about 210) Jeep shut off. It started back up -got food- & headed home. It shut off 4 more times on my way home! I made it home! Changed out the fuel filter! It was clogged big time!

190 ruben1226 answered 5 years ago Ruben from Tampa FL I have Cherokee sport 2000 4×4 4.0L run gray bat when engine its on normal temperature turn of so 1 hour later staring back replace can sensor and crank sensor if you can help me to repair thank 19 people found this helpful.

Why does my Jeep make a pulsing sound when I idle?

The car idles and drives perfectly at slower speeds but on the highway you can really feel the pulses and hear the exact making sounds. The only way to get the pulsing to stop is to give the jeep more gas. It sounds to me like its a missfire somewhere along the engine due to the fact that the exhaust is making sounds from the pulsing.

Why does my Wrangler sputter at low rpm?

If your vehicle sputters under light acceleration and low RPM but becomes increasingly bad the faster you drive, then you want to investigate your Coil Rail. Another tell-tale symptom is if the sputtering is in direct proportion to your RPM, i.e. the faster you drive the faster the sputtering.

Is there a problem with my Jeep Grand Cherokee?

Very often, this will solve the problem. But Jeep Grand Cherokees seem especially prone to more serious transmission problems, and some owners are quite vexed at their inability to determine the causes.

What kind of sensor does a Jeep Wrangler need?

The recommended sensors are the NTK O2 sensor and not any aftermarket or 3rd party sensors. If you are going to self-diagnose your Jeep problems, it’s highly recommended to invest in an OBDII scanner to properly diagnose your problem, which can save you thousands in the long run.

How can I tell if my Jeep Grand Cherokee is shifting?

Turn ignition key ON and OFF three times, finally leaving the key in the ON position. Leave the Overdrive Off Switch in the normal overdrive (ON) position. Immediately begin counting the number of flashes displayed by the Overdrive Off Switch indicator lamp. There will be two sets of flashes, separated by a pause.

Navigation