How much fluid does a Meyer snow plow take?
There is less than a quart of fluid in the unit. IF it is an H Model, there will be about 1 quart in it to drain. Loosen the Drain Plug using an 11/16″ box end wrench or socket (some early units you will need a 5/8″ wrench or socket).
What makes a Meyer E-47 snow plow go left?
A Coil energized, the plow lowers. B coil energized the plow will raise with the motor. C coil energized the plow will angle right with the motor. Just the motor running alone, the plow will angle left, as no valves are used for that function. Make sure you have a CLEAN ground connection on the pump and at the BATTERY.
Is the PA block on the Meyer E-47 obsolete?
The above pictured PA Block is OBSOLETE. A somewhat common problem we find when rebuilding Meyer E-47, E-57, and E-60 plow pumps is the bolts holding the PA Block to the Sump Base are stripped. Not the thread portion, but rather the Allen head of the bolts.
What to do if your snowplow only goes left?
Something to try take the two hoses off the pump, hook them together and turn the plow straight. Now hook the lines back up to the pump and try to raise the plow again and see what happens. If the plow goes left and does not raise then the B coil/valve is at fault. (bad o-rings, or a bad valve) Click to expand… Only angles left, OK.
How to troubleshoot a Meyer E46 solenoid coil?
This troubleshooting guide is primarily for Meyer E46 , E47 and E60 units. Solenoid Check: To check your “A”, “B”, and “C” solenoid coils for magnetism use a screwdriver by placing it on the nut securing the coil.
A Coil energized, the plow lowers. B coil energized the plow will raise with the motor. C coil energized the plow will angle right with the motor. Just the motor running alone, the plow will angle left, as no valves are used for that function. Make sure you have a CLEAN ground connection on the pump and at the BATTERY.
What causes Meyer snow plow to make noise from no fluid?
Frozen, low pump pressure, controller problem all could be the cause. meyer e47 plow wont raise – No fluid, weak motor, frozen. meyers e47 does not move – Frozen. what causes snow plow to make noise from motor but not move No fluid, frozen. meyer snow st remote stuck in overload – See below.
What does the overload light on Meyer plow mean?
ALL Meyer plow Touchpad controllers have built in calculations for each function of how many amps it should take to perform that function. The overload light means one of them is pulling too many amps. Which one? Well here are the basics: Up – Motor Solenoid and B Coil (red wire) get power. Down – A Coil (black wire) gets power.
The above pictured PA Block is OBSOLETE. A somewhat common problem we find when rebuilding Meyer E-47, E-57, and E-60 plow pumps is the bolts holding the PA Block to the Sump Base are stripped. Not the thread portion, but rather the Allen head of the bolts.