Can a new ignition lock cylinder be replaced?
This cylinder is an interchangeable core that can wear over time and make it difficult to start the car. If this is the case, the cylinder can easily be replaced with a new cylinder that can be coded to match your existing car keys.
What happens if you don’t turn the ignition lock?
If the key won’t turn, the car won’t start. When you start a vehicle with a key, the key inserts into an Ignition Lock Cylinder that turns to start the engine. This cylinder is an interchangeable core that can wear over time and make it difficult to start the car.
Where to remove tumbler from ignition lock cylinder?
Along with the cylinder assembly instructions, Dorman included a paper template to help organize the tumbler sequence, and this definitely made the job easier. With a small screwdriver, remove the first tumbler from the old cylinder located closest to the key side of the cylinder.
How do you remove a cylinder from a car?
First, remove the negative cable from the terminal on the battery. Next, unscrew the screws that hold the upper and lower covers onto the steering wheel column. On some vehicles, it may be necessary to remove the steering wheel by disconnecting the wires connected to the horn and then removing the wheel’s retaining nut and washer.
How do you replace an ignition lock cylinder?
Note the numbers on the old tumblers and record them relative to their position on the key. Insert the key into the new cylinder and turn it to the accessory position. Remove the cylinder from its casing and then remove the key. Use a small screwdriver to remove the first tumbler closest to the key side.
If the key won’t turn, the car won’t start. When you start a vehicle with a key, the key inserts into an Ignition Lock Cylinder that turns to start the engine. This cylinder is an interchangeable core that can wear over time and make it difficult to start the car.
Where are the tumblers on an ignition lock cylinder?
Place it on the corresponding spot on the paper key diagram. Continue to remove each of the tumblers from the old cylinder, and use the template (or make a note) to remember their position relative to the key. The tumblers are located on the top and bottom of the cylinder and are stamped with numbers to aid identification.
First, remove the negative cable from the terminal on the battery. Next, unscrew the screws that hold the upper and lower covers onto the steering wheel column. On some vehicles, it may be necessary to remove the steering wheel by disconnecting the wires connected to the horn and then removing the wheel’s retaining nut and washer.