What does the p0935 Dodge line pressure sensor mean?
P0935 DODGE Meaning Line pressure is electronically controlled by the Transmission Control System (TCM) and is measured by the Line Pressure Sensor (LPS). The desired line pressure is continuously being compared to the actual line pressure and is regulated by electronically changing the duty cycle of the Pressure Control Solenoid (PCS).
What does code p0935 mean on a transmission?
What Does Code P0935 Mean? Unlike manual transmissions, which the driver manually selects gears, automatic transmissions shift gears by switching hydraulic circuits to engage and disengage different gearsets. In fully-automatic transmissions, this can occurs without any driver input other than the accelerator pedal.
How to troubleshoot range / performance related code p0933?
How do you troubleshoot code P0933 ? A Range/Performance related code will be set when either a sensor or other component does not perform within the range the PCM (Powertrain Control Module) expects to see, given the current engine load/speed, and information gathered from other sensors.
How to check the hydraulic pressure sensor range?
Circuit Checks – With the key OFF and the ECM and LPS disconnected, check the circuits end-to-end. You should measure 0 Ω end to end and over 10 kΩ to each other and to ground. If any measurements are off-specification, trace and repair the fault.
P0935 DODGE Meaning Line pressure is electronically controlled by the Transmission Control System (TCM) and is measured by the Line Pressure Sensor (LPS). The desired line pressure is continuously being compared to the actual line pressure and is regulated by electronically changing the duty cycle of the Pressure Control Solenoid (PCS).
Where is the p0935 code stored in the clutch?
The clutch uses hydraulic pressure to engage and disengage the clutch as well as shift gears. Pressure is stored in the Accumulator. The Accumulator Pressure Sensor tells the Transmission Control Module (TCM) how much pressure is in the system. If the sensor sends back an implausible signal, code P0935 is stored. No comments yet…
What causes an OBD-2 transmission control module failure?
OBD-II Code Transmission Control Module (TCM) failure is defined as a Hydraulic Pressure Sensor Circuit High The clutch uses hydraulic pressure to engage and disengage the clutch as well as shift gears. Pressure is stored in the Accumulator.
What are the causes of DTC p0935?
Depending on year, make, and model, DTC P0935 may have number of causes. Here are some of the most common. TSB – A few TSBs (technical service bulletins) have been released by various automakers to address this DTC.