Do you need to install drivers for speakers?
Do I need to install drivers for speakers? No. Speakers do not need drivers. If no speakers are working with a computer, the sound card may need to have drivers installed. My computer speakers aren’t working. What should I do? Computer speaker help and support.
Can a 4 channel amplifier be used for rear speakers?
In fact, there are actually a few benefits you’ll get using one 4 channel amp instead of 2 stereo ones to power your front and rear speakers. A 4 channel amplifier is a stereo amplifier with 2 more channels built in to boost (amplify) weak input signals to a higher voltage signal.
What kind of plug do I need to connect my speakers to my computer?
Connecting speakers or headphones to a 3.5 mm mini jack. One of these wires should be connected to the left speaker, and the other should have a 3.5 mm mini plug that connects to your computer’s audio output jack. If your speakers require a power source to amplify the audio, there should also be a power cord.
How do you hook up a radio to a speaker?
You’ll need to separate the speaker wires, cut them, and attach wiring to run to the amp. Remove the radio and disconnect the factory wiring plugs or aftermarket radio’s wiring harness. Cut the speaker wires, leaving enough length to move the wire and to have enough length to connect to the wire freely.
What kind of speakers do rear surround speakers use?
One last question and I’ll leave you alone on this: My rear surround speakers are those angled dipole/bipole types with identical drivers on each side. They are switch selectable monopole, dipole or bipole. How do I set them so I do not have the comb filter issue with them?
Can a factory speaker be connected to an amp?
Factory speaker wires are very thin, with high electrical resistance, so they can cause noticeable power loss when higher wattages try to get through. But amplifiers of 75-watts or less aren’t really affected by this, so running their outputs through factory wiring remains a practical and convenient solution. Let us know what you need
Can a center channel be split into two speakers?
Separate amps will not help with comb filtering. I strongly advise against splitting the center channel into two speakers. You will end up with worse worse than what you have now. OK – I think I’ve got it now. Moving to the heights and wides, can these be small satellite speakers?
How to connect 4 speakers to an amp?
Michael, You can run four speakers with a 2-channel amp by connecting the left pair of speakers to the amp’s left channel speaker terminals and the right pair of speakers to the right speaker terminals – two to a terminal.