How long does jeep run after remote start?
The engine can run for up to 15 minutes before timing out without you getting in, though it must be manually started after two consecutive timeouts.
Why does my Jeep shut off after remote start?
40 people found this helpful. In the instruction manual it states under certain circumstances the engine will shut off when you use the remote starter. My 08 GC did the same thing because the ” check engine” light was on.
How long does it take for Jeep remote to start?
On my remote start feature, everything works but for only 10 seconds then turns off. Jeep starts fine when I insert the key. What am i missing? is your remote a factory or an aftermarket ??
Why does my Car start then immediately shut off?
Answer The most common reason for a vehicle to start, then immediately shut off is engine checking. Compustar and Arctic Start systems monitor voltage or tachometer signals from your vehicle to know exactly when the vehicle has started.
How do I Turn Off the remote start on my car?
Press and hold the foot brake down. While keeping your foot on the brake, press the remote start button on your remote control for 3 seconds like you are remote starting the vehicle. Your parking lights will flash once. (If they flash more than once, you may have to visit the dealer/installer) Turn the vehicle OFF.
Why does my Jeep start and then turn off?
When normally starting the Jeep, if you stop at turning the key to on, you should see the red Security Key light go out. Sometimes it is only one key. If both key react that way, it is most likely the module (separate from the remote lock/unlock module) which I believe is mounted to the steering column under the dash.
On my remote start feature, everything works but for only 10 seconds then turns off. Jeep starts fine when I insert the key. What am i missing? is your remote a factory or an aftermarket ??
What’s the purpose of auto start-stop on Jeep?
The primary purpose of Auto Start-Stop feature is to reduce fleet emissions for the auto manufacturer, not save you gas money. This is why they have devoid us of an option of permanently disabling this function.
How to shut down a jeep ASD relay?
1 Lost 12 volt DC electric power. 2 Sees the spark weak or dead on the ignitor drive to Ignition coil primary pin. 3 Crank sensor bad. 4 Cam sensor bad, or misfiring, CMP. 5 ASD input read back pin fails. 6 Same ASD output read back. 7 Immobilizer active.