How does the stereo work on a Jeep Wrangler?
It pokes through that rear wheel for an unobstructed view of the area behind the Jeep. It looks factory-installed and doesn’t interfere with the removal of that wheel, if that was ever required. Now, the customer will be able to see anything (or anyone) behind the Jeep in all of those blind spots that the Wrangler has – safety first, Jeep lovers!
How to remove a stuck CD in a Jeep Cherokee Laredo?
Use a blank disc or a set of tweezers or a paper clip to attempt to push the disc up into the ejecting track. You can do this by inserting the tip of the object into the player and pushing the stuck CD upwards while pressing or holding the “Eject” button.
How do you remove a radio from a car?
Simply pull from the bottom, then the sides and tilt the bottom out, towards the center console. There are two tabs at the top of the panel that slide under the upper dash trim. These break pretty easy. Then remove the 4 screws that hold the radio in place.
How do you get a CD out of a car stereo?
Press your CD player’s power and eject buttons down at the same time, holding them for about ten seconds. If your stereo has a “force eject” feature, it should spit out the CD.
How to upgrade your Jeep Wrangler TJ stereo?
Simply connect the harness and mount the new speaker in the factory opening. The 6 1/2″ does NOT sit completely in the opening. It actually mounts on the outer edge of the OEM opening, but the Polk Audio speaker cover, covers all of the mounting screws. Time for the amp work. First remove the boat anchor in the center console.
Where is the audio amp on a Jeep Wrangler?
It actually mounts on the outer edge of the OEM opening, but the Polk Audio speaker cover, covers all of the mounting screws. Time for the amp work. First remove the boat anchor in the center console. The one Jeep calls a speaker. I didn’t need to remove the seats or the front portion of the center console.
Can you change the speakers on a Jeep Wrangler?
When you enter your vehicle information, our database will choose the adapter you need to make your factory steering wheel controls work with your new receiver. The Wrangler’s speakers are relatively easy to reach and replace, so you’ll get much better sound with minimal effort.
Simply pull from the bottom, then the sides and tilt the bottom out, towards the center console. There are two tabs at the top of the panel that slide under the upper dash trim. These break pretty easy. Then remove the 4 screws that hold the radio in place.