How do you change the transmission fluid on a Jeep Wrangler TJ?
Open up a bottle of transmission fluid, attach your bottle pump to it, insert the hose into the fill hole and start pumping away. Keep pumping in fluid until it begins to ooze out the fill hole and then reinstall the fill bolt. Tighten this bolt to 14-20 ft. lbs.
Where is the drain plug on a Jeep JK Wrangler?
NOTE: You can also create a drain plug removal tool by cutting the end off of a 17mm allen wrench or H17 bit. 1. Park your Jeep JK Wrangler on level ground. Place an oil catch pan underneath your NSG 370 manual transmission and then, using an H14 allen bit, remove the fill bolt which is located on the passenger side as shown. 2.
How to change the transmission on a Jeep Wrangler?
Using your cut down H17 allen bit or modified coupling nut and 17mm or 11/16″ wrench, reinstall the drain bolt onto your NSG 370 manual transmission. 7. Attach a bottle pump to your Mopar transmission fluid bottle, insert the feeder tube into the side of your NSG 370 manual transmission and then begin pumping the fluid into it.
How big is the drain plug on a transmission?
The drain plug is a 17mm. This dumb tool is a 14mm (fill) and 19mm (useless) Perfect design for tight spaces, mostly bought to use on European vehicles. Helped me drain transmission fluid.
How much fluid does a Jeep front differential hold?
Allow to drain completely and clean gasket surface on cover and axle properly. Once clean use RTV to seal cover and once RTV is dry fill with 75W140 synthetic fluid until its at the bottom of fill hole. Roughly 2.35 Quarts of fluid. Front Differential has a drain plug to drain fluid. Drain and replace plug.
Where is the correct fill level on a jeep transmission?
1st gear: 3.15:1 2nd gear: 1.75:1 3rd gear: 1:1 Lubrication: Inspect and correct fill level every 5,000 miles. The fluid level fill plug is located on the right side of the transmission case. The correct fill level is to the edge of the fill plug hole.
Where is the fill plug on a jeep?
It has been known to survive behind large V8s and was put behind the stock 304 jeep engine from the factory. 1st gear: 3.15:1 2nd gear: 1.75:1 3rd gear: 1:1 Lubrication: Inspect and correct fill level every 5,000 miles. The fluid level fill plug is located on the right side of the transmission case.
What kind of transmission does a Jeep Wrangler have?
In 1987 Jeep released the YJ Wrangler. When ordered with the AMC 258 CI ( 4.2L 258 I-6 ), the YJ was equipped with a french made Peugeot BA-10/5 Transmission. Around the same time, it was introduced into the XJ Cherokee & MJ Comanche.
How much oil is in a jeep transmission?
Fluid Capacity: 4.9 pints (2.45 QTs) of 80 weight gear oil but most recoment Redline MT 90 to protect the interals better slave cylinder is internal for all years and includes a hydralic throw-out bearing.