How do you take out the dash on a Jeep Wrangler?
After two minutes this will disarm the system. To take out the dash you will first need to take out the steering column. To do so, start by removing the steering column cover and knee blocker panels from under the column.
How do you remove a steering wheel from a Jeep Wrangler?
If you have a tilting steering wheel, find the cable attached to the tilt lever and disconnect it. This makes it easier to remove the electrical connectors from the column. This is where the masking tape and Sharpies come in.
What to do if your dash light does not work?
#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.
Where is the airbag on a 1998 Jeep Wrangler?
My Jeep is a ’98 and has the strap you slip out of the box. There are two nuts that can be seen once the box is out. These hold the bottom of the passenger airbag to the firewall and need to be removed. With the glove box out, look through the opening to the upper left area.
How to remove dash panel on Jeep Wrangler JK?
This is a short video on how to remove a 2007-2017 Jeep Wrangler JK dash panel/bezel. You may need to remove your Jeep Wangler dash for a multitude of reasons like, running wires, new radio, adding switches. Removing the dash cover makes it super easy to run wires and hide them like a pro! Loading…
Where is the dash cover on a Jeep Wrangler?
Look on top near the bottom of the windshield and you will see the dash cover piece that spans the width of most of the dashboard. To access the top two screws this needs to come out. Using a flat screwdriver (or pocket knife blade like me), simply pry the cover up until the push tabs pop out. There are four of them.
If you have a tilting steering wheel, find the cable attached to the tilt lever and disconnect it. This makes it easier to remove the electrical connectors from the column. This is where the masking tape and Sharpies come in.
My Jeep is a ’98 and has the strap you slip out of the box. There are two nuts that can be seen once the box is out. These hold the bottom of the passenger airbag to the firewall and need to be removed. With the glove box out, look through the opening to the upper left area.
Do you need to remove the dashboard on a Jeep Cherokee?
You may decide to remove the dashboard on your Jeep Cherokee for several reasons. Whether you are replacing one of the components of the instrument cluster or you need to repair your heating system; you will have to get the dashboard out of the way before you begin.
How do you disassemble a Jeep Cherokee?
Unbolt the top portion of the dash with the socket wrench. Unscrew and the defroster vent cover then undo the retaining clips manually. Remove the cover and the weather stripping by pulling it straight off. Insert the flathead screwdriver under the panels at the bottom of the dash by the doors. Pull down on the screwdriver to pry the panels off.
How do you remove radio from Jeep Cherokee?
Identify the two retainer screws for the radio panel. There is one screw on each side of the radio. Remove these screws with the Phillip’s head screwdriver and slide the panel forward. Unplug the radio’s electrical connectors. Drag the heater control assembly forward.
After two minutes this will disarm the system. To take out the dash you will first need to take out the steering column. To do so, start by removing the steering column cover and knee blocker panels from under the column.
Where is the hot air button on a Jeep Wrangler?
On the back you should see a cable that probably has a foam type covering on it and a red plastic tab that pushes into the housing. With your little screwdriver push this red tab down from the top until it pops out. Then slide the hot/cold air selector all the way to the left until you can see the hook the cable attaches to. Unhook it.