Will a v6 transmission fit a V8 Dodge Dakota?
v8 swap is very easy, the stock v6 tranny will work but it won’t hold up as well as the v8 tranny, and get the v8 computer and wire in the extra 2 injectors into the wiring harness and your set.
Are 5.2 and 5.9 transmissions the same?
There not interchangeable. Other then that,it’s the same. Ask for the build sheet for the 5.2 and the 5.9 then you’ll know the difference.
Will a 5.7 Hemi bolt up to a 4.7 transmission?
The 4.7 and 5.7 Hemi Transmissions have the same bolt pattern , so a Hemi would bolt to you’re trannsmission.. 318-360 , motors won’t bolt to you’re trans..
How do I identify my Dodge transmission?
Open the hood of the truck and locate the transmission fluid container. The vehicle’s transmission information will be located on a plate adjacent to the container. Read the vehicle owner manual and you will be able to identify the vehicle’s transmission information.
Is the Dodge 5.2 a good motor?
5.2 Magnum Reliability The 5.2 Magnum used in Dodge trucks and Jeeps is a pretty solid engine. It doesn’t suffer cylinder head cracks to the same extent that the 5.9 Magnum does. Additionally, the internals and major engine components seem to be fairly strong and adequate for good longevity at stock power levels.
Is a 318 and 360 the same block?
Nope, not the same. Bore size 318 is 3.91. Bore size 360 is 4.00. Crank is different as well.
How heavy is a 46RE transmission?
Technical Details
| Manufacturer | Shift Rite |
|---|---|
| Brand | Shift Rite |
| Item Weight | 300 pounds |
| Package Dimensions | 36 x 36 x 12 inches |
| Item model number | 46RE 2WD 98-99 |
What is the difference between a 46RH and a 46RE?
They both use the same front half up to the bell housing, but the rear is different. The 46RH is longer overall and non computer controlled for shifting. The 46RE is the short one and is computer controlled shift points.
What years did Chevy use the NV3500?
What years did Chevy use the NV4500? The New Venture Gear 4500, commonly called NV4500, is a 5-speed manual transmission manufactured by New Venture Gear and used in General Motors and Chrysler products from 1991–2007.
What is the difference between NV3500 and NV4500?
NV3500 is light duty and aluminum with the bellhousing made as part of the case. A NV4500 has a much higher load rating, granny 1st gear, cast iron case with bolt on aluminum bell, much larger overall and has PTO ports.
What kind of engine does a wrangler Dakota have?
So, there is obviously the K 2.5 I4, the GM “Iron Duke” 2.5 I4, and the AMC 2.5 I4 that was common in Wranglers and also saw service in the Dakota after the K engine was discontinued. On the k engine in the Dakota, to my knowledge it was only used with a manual. I do not know about the AMC engine though.
What kind of transmission does a Dodge van have?
DODGE Model Years Transmission Type Engine Type/Size Transmission Model Van 1990-1991 4 Speed 46RH VAN/WAGON 1500-2500 95-01 3 SP RWD V8 52L 36RH VAN/WAGON 1500-2500 95-03 3 SP RWD V6 39L 32RH VAN/WAGON 1500-2500 95-96 4 SP RWD V6 39L 42RH/RE
Can a T 5 transmission be swapped with a V-8?
These should not be interchanged. Late-model T-5 bellhousings used on earlier Ford V-8 engines will bolt up, but the late-model fulcrum for the fork needs to be replaced with an early-style fulcrum installed on the inside of the housing to align the throw-out bearing fork.
What kind of transmission does a GM T-5 have?
The 1983-92 GM T-5s that were coupled to V-8 engines have a 26-spline, 1-1/8-inch input shaft. The GM 4-cylinder and V-6 T-5s used the 3.52 through 4.03 ratios and were 1-inch, 14-spline input shafts. Later model F-Body world-class versions of the GM T-5s used the lower, 2.95 to 1 ratio gearbox and are the most sought-after for GM applications.