Why is the headlight on my Jeep Patriot not working?
The right headlight is not working, however it does work on the Highbeam setting. I switched the bulb, same problem. I looked and switched the fuses, this also did not fix it,
Why is my passenger side headlight not working?
Passenger side headlight not working. Not open for further replies. Over the winter, the passenger side headlight just stopped working. Naturally, I changed the bulb and nothing. The it dawned on me that neither high nor low beam were working, so I thought it may possible be a ground issue.
What should I do if my headlight bulb is not working?
Suspect a problem with the socket, hot wire, or ground if its a separate ground. You can use an ohm meter or just run a test wire right to the bulb to figure out which wire, then start looking for why. Might just need to freshen up the connections.
When did the 2007 Patriot headlamp bulb fail?
Passenger headlamp for my 2007 Patriot just failed at 136,000km. New H13 bulb didn’t fix. 3 wires to the bulb, the middle is the ground. Measured the voltage on the bad passenger side and it was lower than that of the working driver side.
Passenger side headlight not working. Not open for further replies. Over the winter, the passenger side headlight just stopped working. Naturally, I changed the bulb and nothing. The it dawned on me that neither high nor low beam were working, so I thought it may possible be a ground issue.
Why are the headlights on my Jeep Patriot not working?
Thanks, but both headlights share a single fuse in the Patriot. So if the fuse went, neither headlight would work. Unlike older cars where everything had it’s own fuse and independent mechanism, 95% of the Patriot is computer controlled. Technology…
What to do if your YouTube headlight is not working?
Headlight is not working. Replace headlight relay If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Why are my headlights not working in high beam?
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
Why do I have a hot wire to a low beam?
Then you would have a hot wire to the high beam and a different hot wire to the low beam. Suspect a problem with the socket, hot wire, or ground if its a separate ground. You can use an ohm meter or just run a test wire right to the bulb to figure out which wire, then start looking for why. Might just need to freshen up the connections.
Passenger headlamp for my 2007 Patriot just failed at 136,000km. New H13 bulb didn’t fix. 3 wires to the bulb, the middle is the ground. Measured the voltage on the bad passenger side and it was lower than that of the working driver side.
The right headlight is not working, however it does work on the Highbeam setting. I switched the bulb, same problem. I looked and switched the fuses, this also did not fix it,
Why are my bi-xenon HID low beams not working?
2. My HID Bi-Xenon high beams or low beams are not working or are inverted. This is a similar issue as above, the polarity of the connector’s pins are not correctly aligned. Bi-Xenon HID kits have 3 pins on the harness connector for ground, low beam and high beam connections. You will need to release the pins inside the connector and reorder them.
Then you would have a hot wire to the high beam and a different hot wire to the low beam. Suspect a problem with the socket, hot wire, or ground if its a separate ground. You can use an ohm meter or just run a test wire right to the bulb to figure out which wire, then start looking for why. Might just need to freshen up the connections.
What does it mean when One Headlight is not working?
If one headlight is working, then its not a fuse. Both are powered by the same fuse. A melted connector can also be an indicator of a burned open headlight wire somewhere. Check any other connectors and wires associated with that light.
Where is the ground eyelet on a Jeep Patriot?
On the passenger side, there’s a ground eyelet secured to the frame near the bottom of the antifreeze reservoir. Take the bolt off, remove the eyelet and shine a light on it because it wasn’t obvious at first but the ground wires are all corroded on mine.
Why is the headlight not working on my Jeep Patriot?
Last year, same thing, but on the driver side. My pat has all kinds of issues with wiring getting corroded and failing, causing a mess of electrical issues. If one headlight is working, then its not a fuse. Both are powered by the same fuse. A melted connector can also be an indicator of a burned open headlight wire somewhere.
What does it mean when your headlights don’t work?
With that in mind, it can be tremendously useful to start off by looking at whether both, or just one, of your headlights have failed, and whether or not the high or low beam mode still works. When headlights stop working, it’s usually an electrical problem or an physical issue with the bulbs themselves.
What are the top problems with the Jeep Patriot?
The 2016 model year got a little bit better than the previous years, with the body and paint still being the top problem category. The next highest problem issues with the Jeep Patriot involve the brakes, the engine, and the electrical system.
When did the Jeep Patriot get a facelift?
The Jeep Patriot underwent a facelift in 2011, with minor interior and exterior upgrades for this model year. The front fog lamps were given a smaller size and placed in a different location, with the “Patriot” lettering on the rear bumper removed and replaced with a traditional look.