Why is my Mercedes ml270 CDI slow and gutless?
The STAR machine picked it up straight away. If you’re anywhere near Milton Keynes get over to Autoclass and they’ll give you an honest opinion. As above, have it plugged in to STAR and stop the guesswork. It’s in limp-home mode for a reason. When this happened to my W164 320 CDI it turned out to be the turbo vanes sticking.
What does the ABS warning light on a Mercedes mean?
If the ABS warning light is also illuminated this signals that the braking system has malfunctioned and your brakes may not work properly. In this case the Electronic Brake Force Distribution (EBD) warning light may also be illuminated. Can I still drive with my parking brake and brake fluid light on?
What does it mean when brake warning light comes on?
If it comes on with the brake warning light, it could indicate that the brake system is failing and you should stop straight away and call for recovery if you have breakdown cover. For roadside assistance, you can call the RAC on 0330 159 1111 even if you’re not a member.
Do you need brake light switch for Mercedes?
Very familiar with models such as E 320, C 240, SLK, CLK and several other Mercedes-Benz chassis. Luckily for you this is a very easy repair that you can also perform yourself. All you need is a Brake Light Switch for your Mercedes-Benz model.
Why is my Mercedes-Benz ML 270 not starting?
To release the connections, just squeeze the white clip IN, this causes the jaws of the fitting to expand and allow you to pull out the connection (whilst still squeezing the clip). ps…………check for leaks from any of the 3 ‘caps’ of the high pressure pump as they have been known to leak fuel which will also cause air to enter the system.
What are the most common problems with Mercedes Benz cars?
8 Most Common Mercedes-Benz Problems 1 Rust. Rust behind license plate / trunk area. 2 Engine Mounts. Engine mounts on Mercedes-Benz cars are oil filled. 3 Suspension & Steering Components. Ball joint / front control arm. 4 Window Regulators. Broken window regulator on Mercedes C-Class. 5 AirMatic Components. …
What happens when a Mercedes Benz goes into limp mode?
When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level. The transmission has a dipstick tube but with no dipstick in it.
Are there any problems with the ml270 CDI?
I also have an ML270 Cdi and I have had the dash lights thing. Mine was a faulty wheel speed sensor. If this has a fault it will bring on every light to do with the ABS system and will also prevent the cruise control from working.
Is the Mercedes Benz ml270 a classic car?
I am a classic car restorer, so know my way around cars to a certain degree. However, obviously, something built in 1935 is a world away from what’s under the bonnet of our ML270. It starts up ok and runs good on tick over.
Why are my dash lights not working on my ml270?
The ABS,ETS etc. lights are probably being cause by a faulty or sticky brake light switch which can be easily be replaced for $20. Please update your profile in USER CP to include the year and model of your truck and where you live. Click to expand… I also have an ML270 Cdi and I have had the dash lights thing.
Why does my ml270 gearbox keep locking up?
Check the plug on the gear as it can send oil up to the ecu. If the gearbox keeps locking up it means its not happy and eventually it will be permanently locked and only a computer can unlock. A friend of mine has a 53 reg ML270 and I told him to get it serviced before there are problems.
When did Merc stop making 2.7 CDI engines?
The 2.7 CDI engine was built by Merc for a good few years. The period where I consider it to be one of the best engines that Merc produced was from Late 2003 right up to the time it was replaced by the 2.8 CDI around about 2007/8. It’s was a bit earlier that – it was dropped in 2005 as it would take too much work to make it EU4 compliant.
When to change the timing chain on a Mercedes Benz?
Timing chain is an internal component and should not be changed unless the engine goes bad….You have to dismantle the engine to change it.
To release the connections, just squeeze the white clip IN, this causes the jaws of the fitting to expand and allow you to pull out the connection (whilst still squeezing the clip). ps…………check for leaks from any of the 3 ‘caps’ of the high pressure pump as they have been known to leak fuel which will also cause air to enter the system.
The 2.7 CDI engine was built by Merc for a good few years. The period where I consider it to be one of the best engines that Merc produced was from Late 2003 right up to the time it was replaced by the 2.8 CDI around about 2007/8. It’s was a bit earlier that – it was dropped in 2005 as it would take too much work to make it EU4 compliant.
Timing chain is an internal component and should not be changed unless the engine goes bad….You have to dismantle the engine to change it.
What to do when your Mercedes goes into limp mode?
You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.
What does it mean when your car is in limp mode?
Known as the limp / fail safe / emergency mode is when your transmission is stuck in one gear and doesn’t shift. In this condition, you only get speeds up to 30 mph max. Why does this happen? When the sensor input values from the different sensors inside the transmission]
What causes a Mercedes-Benz transmission to fail?
We see these transmission fail in rare cases when water enters the transmission via the oil cooling lines or the radiator on cars equipped with Valeo radiators. The top part of the radiator on your Mercedes-Benz contains the chamber for the engine coolant/antifreeze while the bottom part contains the chamber for the transmission oil cooling.
What are the common problems with Mercedes diesels?
Here are some common problems that affect many Mercedes-Benz diesel models including E350, ML350, GL350, R350, Sprinter, R320 CDI and BlueTec models. Common problems Diesel Particulate Filter. As Mercedes DPF traps and holds soot, with time it reaches a point when it needs to be ‘emptied out’. This is done by regeneration.
What causes an ECU fault on a Mercedes a class?
Mercedes A Class ECU & Air Mass/Flow Meter This ECU is a very common fault for the Mercedes A Class, it causes the engine management light to come on and fault code for the Air Mass/Flow Meter to be stored in the ECU’s memory. This fault can cause the engine to run rough and idle poorly.
The STAR machine picked it up straight away. If you’re anywhere near Milton Keynes get over to Autoclass and they’ll give you an honest opinion. As above, have it plugged in to STAR and stop the guesswork. It’s in limp-home mode for a reason. When this happened to my W164 320 CDI it turned out to be the turbo vanes sticking.
Can a Mercedes-Benz have a transmission failure?
Very few Mercedes-Benz cars have had complete transmission failure and require transmission replacement. We see these transmission fail in rare cases when water enters the transmission via the oil cooling lines or the radiator on cars equipped with Valeo radiators.
When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level. The transmission has a dipstick tube but with no dipstick in it.
When did the Mercedes Benz ml500 come out?
The ML430 was replaced at this stage by the ML500, a 292bhp monster designed to spike the guns of BMW’s X5. An all new M-Class hit the streets in 2005. In short, a massive hunk of metal.
What’s the price of a Mercedes Benz ML320?
Whilst undoubtedly launching the M-class firmly into the premium 4×4 bracket, these prices significantly undercut equivalent specification Range Rover figures, with the ML320 retailing in the same ballpark as a top-end Jeep Grand Cherokee.
What are the common problems with Mercedes key fobs?
Common Mercedes Key Fob Problems Go to top 1 Mercedes key fob not working after battery change 2 Mercedes remote doesn’t work anymore 3 Keyless remote doesn’t lock/unlock the car 4 Mercedes key fob won’t unlock doors 5 Panic button doesn’t work 6 Trunk unlock doesn’t work
What are the problems with the Mercedes C class?
The 2011 C-Class has a well-known and highly publicised problem with its steering system. The unresponsiveness and the strange noise are being caused by a problem with your power steering pump and the fluid line. This will usually manifest as a leak.