Why is my hold light flashing on my 1994 protege?
My Hold light is flashing on my 1994 automatic Protege. The Hold button no longer works. Tranny wont shift into 4th. PLEASE HELP GUYS I own all BG’s! swap to a 5spd….QUICK! Eat ****. thats all the help you got aye? Bham, WA.
Why does my Mazda Protege brake light flicker?
As the title states, on my 2002 Mazda Protege the red emergency brake light indicator flickers randomly while driving. I notice it comes on more on acceleration and is usually off while braking. I am guessing it’s a sensor issue.
Why is my hold light flashing on my car?
It turns out that where the cable comes up from the center of the gear shifter tube (on the automatic)and bends at the top, that the insulation on that thin cable had worn. In other words, it was shorting out.
What to do if your hold light is flashing?
If your hold light is flashing, (and ESPECIALLY if it wont go into 4th gear) you need to have your transmissin serviced. Your Tranny controller could be wigging out as well. I would highly recommend that you change your tranny filter, and replace the fluid. While you are at it, go buy a $40 auto tranny cooler from AutoZone and install that as well.
Why is my Mazda 323 Astina flashing hold light?
It could be that the AT needs a top up of fluid, the clutch bands or torque converter slipping or something more terminal. If left unattended, then it can continue to get worse, force the car into either ‘limp home’ mode or prevent you from driving the car.
Where is the hold button on a Mazda 323?
The “Hold” you are referring to is in regard to the Overdrive/top gear lockout. The button located on your gear lever just below the “T” This button is for holding 3rd gear when going up steep hills etc. I just verified this with our Astina. So, it’s probably just a loose wire. Hopefully! Good Luck!
What should the resistance be on a Mazda 323?
The resistance reading between the two pins in the electrical connector should be around 250 ohms – mine was open circuit (‘infinite’). Mazda part number is FN01-21-550 and I got mine on eBay.
What’s the resistance of a Mazda pulse generator?
Also called a “Pulse generator”, this inductive pickup is essentially just a coil of (fine) wire around a steel core. The resistance reading between the two pins in the electrical connector should be around 250 ohms – mine was open circuit (‘infinite’). Mazda part number is FN01-21-550 and I got mine on eBay.