Why does my snowmobile engine not start up?
When the starting fluid or carb cleaner is sprayed in the intake of the carburetor, the engine should fire, which could then draw the gas through the fuel system. If the gas is not being drawn through, the engine will stall after it is done running off of the starting fluid.
What to do if your snowmobile engine floods out?
If the engine is really flooded, you can drain the excess gas from the drain plugs that many sleds have located on the lower-end of the case. If your sled floods out immediately or if it is not getting fuel to the combustion chamber, it is time to either clean or rebuild you carbs . Dennis Kirk has the best selection of carb kits for snowmobiles.
Why does my jet ski engine not start?
Spark plugs are often the problem if your jet ski engine turns over, but doesn’t start, especially if you have a 2-stroke jet ski. Take the spark plugs out and examine them to see whether they’re wet or dry. If they’re dry and light brown in color, you have the correct fueling.
What are the symptoms of a faulty Yamaha Virago starter?
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
Why does my Yamaha Vmax bike not start?
So – it may appear that the battery is old, dead, etc.. usually owners will replaced the battery – and find that this doesn’t fix the problem. Consequently – when riding the bike you may notice the that battery will drain, so that after a few hours of riding – the motorcycle won’t start.
Why is my Vmax not connecting to my Charger?
If you do not have a voltmeter, hook up a charger, if you have no current flow, amps on the charger, the battery is more than likely the culprit. You may have jiggled the battery and caused a momentary connection. Hey guys, thanks for the suggestions.
Where is the rectifier on a Yamaha Vmax?
Finally we looked at the regulator/rectifier under the left rear passenger peg. On earlier model V-Max’s, the regulator/rectifier is much different than the later model. The new model is much more heat tolerant and has a ground that connects directly to the negative battery post.
What should I do if I take my seat off my Yamaha Vmax?
If your going to take your seat off and remove the battery try this next time, apparently on your positive cable there should be electrical tape put there by the factory. unravel the tape. There should be a crimp there joining more than one wire together.
What to do if your snowmobile stops running?
If I blow it out and clear out the pulse line, i can get it to fire again but then it quits. Once the motor is hot it will run great. If your getting fuel in the pulse line it sounds like you have a problem in the fuel pump.Torn gasket,diaphram,disc.Most you can get a rebuild kit for fairly cheap.
What to do if carb goes in easy on snowmobile?
Put in hole under choke cable in carb, half choke should slightly grip the tube. If you have it on half choke and tube slides in and out easy, that’s the problem. It shouldn’t go in at all on full choke. It doesn’t open for fuel, it closes off air.
When is the best time to start a snowmobile?
When the motor is finally running I can shut it off and start it right back up with no issues. The sled runs great when it is running, but the whole key is to get it started when it is cold. I believe I have the fuel lines correct and I know the Carbs are all clean.
Is it hard to start a snowmobile when cold?
Started just fine in the previous owners heated garage when cold, but when I got it home it was a bitch to start, took something like 10 pulls just to get it to fire. Then a few more to get it to run and stay running. Temp was around 0*F.
When the starting fluid or carb cleaner is sprayed in the intake of the carburetor, the engine should fire, which could then draw the gas through the fuel system. If the gas is not being drawn through, the engine will stall after it is done running off of the starting fluid.
Why does my Briggs Stratton engine pull hard?
All of sudden the cord on my 4-stroke pressure washer Briggs Stratton engine is really hard and jerky-like when I pull to try to start it, it pulls a little way then stops, then I can pull it a little more, but can’t pull a full pull to start the engine. When I take out the plug it pulls freely.
If I blow it out and clear out the pulse line, i can get it to fire again but then it quits. Once the motor is hot it will run great. If your getting fuel in the pulse line it sounds like you have a problem in the fuel pump.Torn gasket,diaphram,disc.Most you can get a rebuild kit for fairly cheap.