Why did my LED lights stop working all of a sudden?
Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. Incorrect Power Source – Make sure to double check which power source your lights require. LED strip lights are available in 12 or 24-Volt versions.
Why would sockets not work?
Usually, the culprit is either a tripped breaker or a bad connection. The outlet might have a bad connection, or the circuit breaker might need to be reset. Luckily for you, you might be able to find the solution when you take these steps, and you may not need to contact professional.
Why are my LED lights failing?
Temperatures are too high (or too low) LEDs shouldn’t be placed in tightly enclosed fixtures unless they’re approved for enclosed spaces. When heat can’t dissipate from the heat sink, it can cause lamps to fail prematurely. Also keep the surrounding environment in mind.
Why are my plug sockets not working in one room?
The most likely cause is a tripped breaker. This can happen when the electrical circuit is overloaded, or a defective appliance or damaged cord short-circuits the system. First, you need to unplug all the appliances in the room, since one of them likely caused the safety device to blow.
How do you troubleshoot an outdoor light?
Locate the circuit breaker which provides power to the light switch and make sure it is not tripped.
- If the circuit is tripped locate the problem within the circuit wiring.
- Make the Correction: Repair the damaged wire and clear the fault.
- Reset the circuit breaker.
- Test the light fixture.
What to do when lights suddenly won’t work?
Push the reset button in. If it clicks as you push it, this is likely the problem. Go see whether your lights now work. If not, continue attempting to reset any other GFCIs by pushing the reset button. If you have checked all of them, check again. Look behind couches and beds. If you can’t find any more, then go to the circuit panel.
Why did my old LED light stop working?
After switching old light sources to LED, problems often occur with old halogen transformers. For a trouble-free operation you should use a suitable LED transformer. Operation on motion detector?
When to call an electrician when your lights don’t work?
If item 8 proves that the switch isn’t getting power (and you’re sure it’s not due to a tripped or faulty breaker or blown fuse), you might have an interruption somewhere along the circuit path. It’s probably time to call an electrician. At least you can’t blame it on your reliable old fixture.
Why does my light ballast not turn on?
One clue that your ballast is the reason for a non-working fluorescent light is the light bulbs struggle to turn on. As I said in the intro, we noticed this happening over a 3-4 week period. A good way to check that your ballast is the culprit is to turn on a voltage detector and hold it next to the wires supplying power to the ballast.