Where is the SRS diagnostic code on a 1992 Volvo?

Where is the SRS diagnostic code on a 1992 Volvo?

SRS Onboard Diagnostic Codes: 1992 and Prior Cars [Tip: Bob] There are three possible locations for SRS test point. In 1992+ carswith two diagnostic test socket boxes (box “A” has the probe, the test button, and the LED readout lamp) at the left strut tower, socket 5 in box “B” is SRS. Accessing code and resetting is same as for check engine light.

When does the SRS light flash on a Volvo?

Turn the ignition on so the dash warning lights are on and wait 15 seconds. Ground the test terminal for 2 full seconds. The SRS light will flash immediately when the connection is first broken. This is not a fault code.

When to replace Crash Sensor in Volvo 940?

c. Replace crash sensor. SRS Onboard Diagnostic Codes: 1993+ Cars. Later 940 and 960 cars have an onboard diagnostic system for the Supplemental Restraint System that both monitors the system and stores any fault codes for later diagnosis.

Where are the SRS Test points on a Volvo?

There are 4 fuse holders across the front of the fuse box, some of these do not have fuses. The second from left would be SRS test point. It has a terminal on one side only. You plug in to this socket and ground it to read/ reset code.

What do you need to know about air bag SRS?

SRS Onboard Diagnostic Codes: 1992+ Cars “Bad” Crash Sensor and Wiring Connector Faults Replacing SRS Crash Sensor Control Unit Air Bag and SRS Components Lifetime Seat Belt Mechanism Repair Seat Belt Retraction Reset Seat Belt Button Replacement Seat Belt Replacement Air Bag Anti-Theft Devices SRS Cautions.

Where is the SRS light on my Volvo?

This is an electrical connector found in the steering wheel which maintains communication between the SRS computer and your steering wheel. However, over time it can fail and the warning light can activate. The computer will log a code in the event that this happens, indicating this precise problem.

What to do if your SRS light does not reset?

Often they will not reset after just one, or even two readings. If you still have SRS trouble codes, try this as a last resort. Disconnect the negative battery terminal clamp. Let the car sit for 1/2 hour. Reconnect the negative terminal clamp and drive the car. Do this three times. If the SRS light re-sets, fine.