Where is the oil pressure switch located on my 2002 Grand Cherokee?

Where is the oil pressure… Where is the oil pressure switch located on my 2002 Grand Cherokee 4.0 Lwhere is the oil pressure sensor on my 2002 Grand Cherokee 4.0 L Show More Show Less Ask Your Own Jeep Question Share this conversation Answered in 4 minutes by: 9/6/2012 Jeep Mechanic: Ron Z., – Jeep Tech – replied 8 years ago Ron Z., – Jeep Tech –

Where can I find the oil pressure switch?

This varies depending upon the model, but a good rule of thumb is to look near the oil filter. Draining the oil pan first will give you better access to the switch. After draining it into a container, you can remove the oil filter. It should be connected to a cable, which you can unplug after you remove the rubber covering.

How do you replace a transmission oil pressure switch?

Step 2: Grab a creeper, flashlight, and tools for the job. Slide under the vehicle and locate the transmission oil pressure switch. Step 3: Remove the harness from the switch. If the harness has brackets securing it to the transmission, you may have to remove the brackets to get the harness out of the way from the switch mounting hardware.

How can I tell if my oil pressure switch is malfunctioning?

The surest way to tell that the oil pressure switch is malfunctioning is a warning light that either never turns off, or never turns on. At that point, the switch is not regulating the light according to the oil pressure.

Where is the oil pressure switch located on?

01 Grand Cherokee 4.0 I installed 4 oil pressure switches. 01 Grand Cherokee 4.0 I installed 4 oil pressure switches. They all hang up on 36psi, tested oil pressure,held @ 65 cold, 35 hot What am I missing?…

Where is the oil pressure sensor on a Honda Accord?

Please read everything! The Oil Pressure Sensor is located on the passenger’s side, rear, lower part of the engine, just above the starter. It has 3 wires: Violet/Black, Grey/Yellow, and Black/Light Blue.

Where is the cabin air filter located on my 2000 Jeep Grand Cherokee?

This model is also known as Jeep WJ. Where is the cabin air filter located on my 2000 jeep grand cherokee? Is this a good question? @holbrooks all 1999-2004 Grand Cherokee WJ series models feature a housing for installation of a cabin air filter but no models have ever come with the filter as standard.

How many miles does a 2002 Jeep Grand Cherokee have?

I have had my 2002 Jeep grand Cherokee since 2008 and it already had 67,000 miles on it. It is the straight 4.0 ltr 6. I now have 187,000 plus and it runs as great as the day I bought it.

Where is the neutral safety switch on a Jeep Grand Cherokee?

Great, can you locate the neutral safety switch on the left side of the transmission, just above the oil pan and disconnect the connector and ground the black/white wire and see if the engine will start when you turn the key to the start position. Ask Your Own Jeep Question.

What should oil pressure be on Jeep Grand Cherokee?

After an oil change one day, it would go up to 80 psi and when the rpm’s would go up, the oil would go down to 60 psi. Anyways, this one I got off of Mopar Overstock. But even aftermarkets work pretty well. This one happens to be a 2001 Jeep Grand Cherokee. I find that the part number does crossover to many vehicles in the Chrysler family as well.

What’s the oil pressure on a Chrysler 4.0L?

The Chrysler 4.0L is one of the toughest engines out there, but even high oil pressure will cause issues. My gauge used be sitting around 40 psi, then all of a sudden it started jumping to 60 psi for quite some time.

What kind of oil switch do I need for my Jeep Grand Cherokee?

Your Jeep Grand Cherokee will be happy to know that the search for the right Oil Pressure Switch & Sender products you’ve been looking for is over! Advance Auto Parts has 31 different Oil Pressure Switch & Sender for your vehicle, ready for shipping or in-store pick up.

How to replace oil pressure switch on Jeep Wrangler?

Replaced old oil switch, worked great in 1997 Jeep wrangler. Now have an oil pressure reading and the check engine light is off. It is difficult to reach. You may need a 1 1/16 inch (very) deep set socket to remove the old one. It came with sealant on the threads so I did not need to apply Teflon tape. I was able to hand tighten in.

Where is the oil pressure sensor on my 2012 Jeep Grand?

Ask Your Own Jeep Question Jeep Mechanic: Ron, ASE Certified Technician replied 2 years ago Your oil pressure sending unit on the 3.6 engine is located on the back side of the oil filter housing under the intake manifold. In order to access it for replacement, you are going to need to remove the intake manifold. See its location in the link below.

What kind of oil does a Jeep Grand Cherokee use?

2004 jeep grand cherokee 4.7 v8 special edition laredo. hard to start, idles rough at about 700rpm, cleaned the throttle, changed tps, good fuel pressure doesnt overheat or have milky oil. Also stalls… read more Marc Mechanic Associate Degree 2,301 satisfied customers I have a 2012 jeep grand cherokee 6.4 was looking for the

Where is the oil pressure sensor on my Jeep Grand Cherokee Laredo?

1994 jeep grand Cherokee Laredo -years ago had same problem as now and a mechanic replaced a sensor – car runs and then shuts off – mechanic years ago replaced a sensor – where is it and what is it ??… read more Dan Automotive Technician Vocational, Technical or Trade Scho

What’s the problem with 5 lb oil pressure?

FOUND PROBLEM! | Jeep Garage – Jeep Forum 5 lb oil pressure at idle… FOUND PROBLEM! I know, everyone is probably saying “Oh man, not another low oil pressure thread” but this has a solution.

Why is my oil pressure so low in my Jeep?

I was beginning to wonder about this, and started to get pretty irritated. i installed a mechanical gauge to be certain it was true. i got p!$$ed the other day and dropped my oil pan (with intentions to put in a High Volume oil pump) and say something shiny by my cam…

Is there a solution for low oil pressure?

I know, everyone is probably saying “Oh man, not another low oil pressure thread” but this has a solution. I recently rebuilt my engine and have yet to put many miles on it. (working on it little by little to get it how i like) I bought a full rebuilt kit for it. including new oil pump.