Where is the keyless entry module on a 93 villager?
On my ’93 Villager there is a green/red stripe wire which goes from the door lock actuator assembly to power door lock module (or the keyless entry module, if you have that). (the modules are in the center console area…) I cut this wire inside the driver’s door.
What happens if the ECM fails on a car?
The fuel and ignition systems, as well as several other engine management functions, of many vehicles are controlled by the ECM. If the ECM or it’s relay fail, the entire engine management system will be left without power and will not function as a result.
What was the problem with my 93 villager?
I just repaired the problem on my ’93 Villager, and it was caused when the wiring harness to the driver’s side door manual lock was pinched between the interior door panel and some metal part inside the door. The insulation wore through and was grounding the circuit against the metal part.
When do you need to replace the ECM power relay?
If there is no power when the key is inserted, the engine will not start, or the battery is dead, you may need to replace the ECM power relay. 1. No power when the key is inserted 2. Engine will not start 3. Battery drain or dead battery Average rating from 130,153 customers who received a Vehicle Engine Electrical Inspection.
On my ’93 Villager there is a green/red stripe wire which goes from the door lock actuator assembly to power door lock module (or the keyless entry module, if you have that). (the modules are in the center console area…) I cut this wire inside the driver’s door.
What happens when you disconnect the battery on a car?
The best way to do this would be with a scanner, but if you don’t have one, disconnecting the battery will do the trick on many vehicles. However, disconnecting the battery will not only erase diagnostic trouble codes but also erase drivability, security and radio codes in many vehicles.
I just repaired the problem on my ’93 Villager, and it was caused when the wiring harness to the driver’s side door manual lock was pinched between the interior door panel and some metal part inside the door. The insulation wore through and was grounding the circuit against the metal part.
How to disconnect a car battery to reset the computer?
Different cars will have different procedures, but with most, just driving the car will do the trick. If you use the baking soda mixture instead of cleaner, mix 1 tablespoon of baking soda into 1 cup of water. Thoroughly rinse the battery with clean water to remove all of the solution.
Where are the spark plugs on a Mercury Villager?
Locate the spark plugs at the side of the engine. These sit about a quarter of the way down the height of the engine on a Villager.
When did the Mercury Villager minivan come out?
The Mercury Villager is a type of minivan produced by Ford between 1993 and 2002. One of its most popular features is the movable seats that give the owner the option of using it as a five-seater vehicle or as a van with large cargo space.
The best way to do this would be with a scanner, but if you don’t have one, disconnecting the battery will do the trick on many vehicles. However, disconnecting the battery will not only erase diagnostic trouble codes but also erase drivability, security and radio codes in many vehicles.
Different cars will have different procedures, but with most, just driving the car will do the trick. If you use the baking soda mixture instead of cleaner, mix 1 tablespoon of baking soda into 1 cup of water. Thoroughly rinse the battery with clean water to remove all of the solution.
Why is the power lock on my door not working?
The electrical contact that signals the power locks from the keylock was evidently activating some of the times when the door closed. Mechanically something inside the lock assembly was making the electrical connection when jarred. The proper solution was probably to replace the lock assembly. But that wasn’t my solution.
The electrical contact that signals the power locks from the keylock was evidently activating some of the times when the door closed. Mechanically something inside the lock assembly was making the electrical connection when jarred. The proper solution was probably to replace the lock assembly. But that wasn’t my solution.
Is there an anti theft system on a Mercury?
Contrary to popular belief, Ford, Lincoln and Mercury vehicles do not come equipped from the factory with a standard alarm system. Instead, the Ford Motor Company equips its vehicles with a passive anti-theft system, known as P.A.T.S.
How to reset an anti theft system for a Mercury Mountaineer?
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.
Is there debouncing on the smart entry controller?
Noisy Door Lock Switches/Lack of debouncing on the door lock switches I would expect the Smart Entry controller to have some amount of switch contact debouncing built in, but apparently there is none or inadequate debouncing of the switch contacts.
Why does my front door lock not work?
The switch contacts can be disturbed causing this momentary break through a vibration like opening one of the doors. In my case, the door locks would often activate when we were opening the passenger side front door. Here is fix from Steve Cutchen who fixed his door lock problem by the following:
Noisy Door Lock Switches/Lack of debouncing on the door lock switches I would expect the Smart Entry controller to have some amount of switch contact debouncing built in, but apparently there is none or inadequate debouncing of the switch contacts.
Is there a color diagram for a Mercury outboard?
Most models also have black-&-white-only but require Adobe Acrobat or compatible PDF reader to open. Most diagrams are only listed as PDF for the moment but all will eventually have color versions posted.