Where is the ignition switch on a VW Jetta?
The contact owns a 2011 Volkswagen Jetta. The contact stated that the ignition cylinder seized and the vehicle was unable to start. The vehicle was not taken to be diagnosed or repaired. Stone mountain Volkswagen (3500 stone mountain hwy, snellville, GA 30078, (678) 367-4286) and the manufacturer were notified of the failure.
What happens if the ignition key is stuck on a Jetta?
Ignition key stuck in ignition switch in the on/run position and will not turn off or come out of ignition. See all problems of the 2009 Volkswagen Jetta . Ignition switch was stuck in the on position with the engine running. The car was stopped and in park in a driveway.
Why is my Volkswagen Jetta not turning off?
Currently vehicle is now having to be towed to mechanic as key cannot be turned. This seems to be a recurring issue with Volkswagen vehicles. Ignition switch would not turn off, could not turn off engine. See all problems of the 2015 Volkswagen Jetta .
Is there a recall on a 2013 VW Jetta?
Tl- the contact owns a 2013 Volkswagen Jetta. The contact received notification of NHTSA campaign number: 19v615000 (electrical system, steering) however, the part for the recall repair was unavailable. The contact stated the manufacturer exceeded a reasonable amount of time for the recall repair.
What to do if your VW key is stuck?
This type of problem can occur to other VW models and Audi as well. If your VW Key does not turn past the accessories position, or if it does not turn at all, or if the key is stuck in the ignition cylinder, we have the solution for you and you do not need to spend on diagnostics fee through Dealer or Tow it to a mechanic shop.
Do you need a new ignition lock cylinder for a Volkswagen Jetta?
If your keys are starting to feel loose in your ignition or if you’re having a hard time turning the cylinder after you insert your keys, a new ignition lock cylinder for your Volkswagen Jetta is in order.
Where is the ground pin on a Jetta clutch?
To ground pin 4, disconnect the switch connector from the master clutch cylinder. Unwrap the electrical tape enough to see the wires. Pin 4 will go to a purple/black wire.
https://www.youtube.com/watch?v=n9vGoUzRmcU