Where is the electronic throttle control on a 2008 Dodge Avenger?

Where is the electronic throttle control on a 2008 Dodge Avenger?

The 2008 dodge avenger throttle position sensor is located on the throttle body that is positioned on the right side of the engine under the air filter housing.

How do you reset the throttle control on a Dodge Avenger?

Slowly press down on the accelerator pedal until it’s all the way down to the floor, and then slowly release it until it’s all the way back up in the resting position. Turn off the ignition.

What are the symptoms of a bad electronic throttle control?

Rather than moving a cable, ETC uses sensors to inform the ECM of the position of the gas pedal, and when it fails, symptoms can be severe. Some of these include sudden idle surges and engine stalling, an engine light that flashes intermittently, or a massive drop in mileage.

What is the electronic throttle control on a Dodge Avenger?

The lightning bolt indicator on the Avenger’s dash is the Electronic Throttle Control (ETC) light. It signifies a problem with the throttle system that controls the amount of fuel provided to the engine. Problems with the throttle body sensor and the throttle body can cause the lightning bolt to illuminate.

How do I reset my electronic throttle control manually?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.

What causes an electronic throttle control to go bad?

In this case, the problem may be caused by a miscommunication link from the throttle controller and the engine’s air fuel mixture which is regulated by the mass air flow sensor on many cars. In most cases, issues with the throttle controller are electric, either caused by a damaged sensor or electrical relay.

How do I get my 2008 Dodge Avenger out of limp mode?

How do you reset limp mode?

  1. Bring your car to a complete stop.
  2. Shift your automatic transmission into PARK.
  3. Turn the ignition switch to OFF.
  4. Wait 10 seconds.
  5. Turn your vehicle back on.
  6. Select the gear of your choice.

Is there any recalls on a 2008 Dodge Avenger?

There have been 6 safety recalls issued from NHTSA. Summary: CHRYSLER IS RECALLING 180,963 MY 2007-2008 SEBRING AND DODGE AVENGER VEHICLES EQUIPPED WITH A STANDARD TIRE PRESSURE MONITORING SYSTEM (TPMS). THE RECALL IS EXPECTED TO BEGIN ON OR ABOUT APRIL 15, 2008. OWNERS MAY CONTACT CHRYSLER AT 1-800-853-1403.

What does a red lightning bolt mean on a Dodge Avenger?

The lightning bolt means there is problem with the spark or your ign either way it’s not good I’m sorry. 25 people found this helpful.