Where is the blend door actuator on a 2006 Silverado?
The 2006 Chevrolet Silverado is actually fitted with two different blend door actuators; one is located on the driver’s side, and one is located on the passenger’s side.
How do you reset the blend door actuator on a 2005 Chevy Silverado?
To reset the 2005 chevy silverado door actuator you must remove the 10a hvac 1 fuse with the key off, wait for a few minutes and then reinstall the fuse.
How do I reset my GM blend door actuator?
Replace it, and then turn on the ignition, run the truck for 1-2 minutes, then turn the truck off. Wait for between 10 and 30 seconds, and then turn the truck back on. Important to note that You shouldn’t touch the controls through this entire process. The reset is complete.
How do you test a blend door actuator?
To test the blend door actuator, disconnect your vehicle’s negative terminals. If your vehicle has radio code, ensure you write it down, or better still, you might perform a calibration. You might decide to take your vehicle to a mechanic garage if you don’t have a calibration machine.
What are the symptoms of a bad blend door actuator?
The symptoms of a bad blend door actuator include a lack of heat or air conditioning, or failure of air to blow through some or all of the vents. The actuator motors may also make a noise if they’ve failed, but this isn’t always the case.
Where is the blend door actuator?
The Blend Door actuator is located in the center of the core box, up under the dash. The Mode Door actuator is on the left, and the Resirc Door actuator is at the top of the dash near the windshield.
What is a blend door actuator?
A blend door actuator is made up of an electric motor that turns a plastic gear set in one direction or another which is connected to an air control door pivot at the final drive of the unit.