Where are the fuses in the XJ power window?
There are no blown fuses in the fuse block in the passenger side footwell, the driver side footwell, or the auxiliary fuse block under the hood on the left side of the engine compartment, nor is the in-line fuse by the battery blown. There is continuity between ground on the car and the ground terminals in the connector to the switch.
Why is my XJ power window not working?
If the circuit appears to be fundamentally in order but a window or windows don’t operate it is very likely that the switch is faulty. In nearly all cases the switch contacts are simply dirty.
How to fix a window with a blown fuse?
1 Locate and check the fuse for the problematic window motor. If it’s blown, replace the fuse. 2 Remove the door panel. Locate the securing screws, usually behind covers or trim, and undo them. 3 Check the electrical input on the power and ground wires, which are generally the two largest wires connected to the window motor. …
How to fix a bad electric window switch?
Attach the multimeter to the wires, then activate the window switch with the car’s key in the on position. If you are getting power in both directions of the switch, then the electrical wiring to the motor is good, and the motor should be replaced.
There are no blown fuses in the fuse block in the passenger side footwell, the driver side footwell, or the auxiliary fuse block under the hood on the left side of the engine compartment, nor is the in-line fuse by the battery blown. There is continuity between ground on the car and the ground terminals in the connector to the switch.
How to troubleshoot XJ Series III power window circuit?
Checklist for inspection and repair of the XJ Series III power window circuits and relays. “My right side front door window came out of the track resulting in it jamming. After a few cycles of trying to free it up by alternate up and down selections on the switch, something clicked and there was no more power to the switch.
Is the rear window on my XJ working?
The right side rear window worked before this incident and does not afterward. It’s switch connector also has continuity to ground at the proper places, but no +12v. The left side windows work fine, as does the sunroof. What am I missing? Thanks to any who can enlighten me.”
The right side rear window worked before this incident and does not afterward. It’s switch connector also has continuity to ground at the proper places, but no +12v. The left side windows work fine, as does the sunroof. What am I missing? Thanks to any who can enlighten me.”
Checklist for inspection and repair of the XJ Series III power window circuits and relays. “My right side front door window came out of the track resulting in it jamming. After a few cycles of trying to free it up by alternate up and down selections on the switch, something clicked and there was no more power to the switch.
How to reset the anti pinch in Jaguar?
Workaround is to close it in ever decreasing increments – until its 99%closed. Then leave it at that. Click to expand… Have you tried the window reset procedure open it keep switch pressed for 3 seconds after it has fully opened then do the same on closing, that should reset the anti pinch for the window.
How do you disconnect a socket on a Jaguar XJ?
If you need to disconnect one from the fixture at either end, don’t just yank. Insert a tiny screwdriver into the slot along the side of the socket and twist to spread it a little, and the fiber will come out easily. It has a little brass fitting on it with a lip. To put it back, simply press it in until it clicks.
Where to put electrical fuses on a JAG?
Since Jag electrical connections tend to corrode, it is suggested the owner keep a tube of this stuff around and use it. The first place to apply it is on both ends of each fuse you can find.
Where is the fuse box located in a Jaguar?
3. Passenger compartment fuse box. The fuse box is accessed through the flap behind the rear centre armrest. 4. Secondary luggage compartment fuse box. CHANGING A FUSE Always turn off the ignition system and the affected electrical circuit, before replacing a fuse. Fit Jaguar approved replacement fuses of the same rating and type, or fuses of
If the circuit appears to be fundamentally in order but a window or windows don’t operate it is very likely that the switch is faulty. In nearly all cases the switch contacts are simply dirty.
How to fix a Jaguar front door window?
Detach the front door window regulator and motor. Remove the front door window regulator and motor. Disconnect the front door window regulator and motor electrical connector. NOTE: Make sure the cable from the motor is the outermost cable. To install, reverse the removal procedure. Tighten to 6 Nm .