When to set minimum throttle for brushless motor?
We set the Minimum Throttle value to the lowest value where all 4 motors start to spins smoothly (for example if motor 1 start to spin at 1120, motor 2 at 1130, motor 3 at 1110, motor 4 at 1140, we set Minimum Throttle to 1140). This ensure the ESC and Brushless motor does not stop completely or desync mid-air when doing a flip.
What should the RPM be at full throttle?
If you calibrate the ESC to the true full range (2000), and then set max_throttle to 1850, the actual RPM at full throttle should then be lower. When you check these values in BLHeliSuite, you might find them to be a slightly different from one ESC to another, so we need to make sure they are the name by adjusting them.
Is there an item that does not work with Full Throttle Remastered?
This item is incompatible with Full Throttle Remastered. Please see the instructions page for reasons why this item might not work within Full Throttle Remastered. This item will only be visible to you, admins, and anyone marked as a creator. This item will only be visible in searches to you, your friends, and admins.
When to use maximum throttle or minimum throttle?
When we do a roll, pitch or yaw movement to an extreme, for instance a 360 roll, we cause 2 motors to spin at 100% (Maximum Throttle) and the other two to spin at 0% (Minimum Throttle). This is where the Minimum Throttle value comes in.
We set the Minimum Throttle value to the lowest value where all 4 motors start to spins smoothly (for example if motor 1 start to spin at 1120, motor 2 at 1130, motor 3 at 1110, motor 4 at 1140, we set Minimum Throttle to 1140). This ensure the ESC and Brushless motor does not stop completely or desync mid-air when doing a flip.
What do you call a 2 to 1 throttle stop ratio?
This is called a 2 to 1 ratio. Learning your ratio will allow you to correct for changing air conditions. If you are using an ET prediction program, you will need to enter this ratio into your prediction program. Your throttle stop ratio is highly dependent on your “throttle stop rpm”.
If you calibrate the ESC to the true full range (2000), and then set max_throttle to 1850, the actual RPM at full throttle should then be lower. When you check these values in BLHeliSuite, you might find them to be a slightly different from one ESC to another, so we need to make sure they are the name by adjusting them.
When we do a roll, pitch or yaw movement to an extreme, for instance a 360 roll, we cause 2 motors to spin at 100% (Maximum Throttle) and the other two to spin at 0% (Minimum Throttle). This is where the Minimum Throttle value comes in.