When to replace your Jeep Liberty engine control computer?
Its brawn is only as good as its brain, however. This is why it’s important to replace your Jeep Liberty engine control computer whenever you notice problems such as higher than normal fuel consumption, a persistent check engine light or rough automatic shifting.
Can you swap an engine in a Jeep Liberty?
If I get my friend to do it… he bleeds Jeep, and everyone that knows him, takes thier jeeps to his house to work on.. He always has a few jeeps of his own, and many part jeeps (no Libertys), and he will have my existing Jeep engine for any parts he might need, as it still runs and drives, it just has a lower end tap, so time is limited.
Where is the ECM module on a 2002 Jeep Liberty?
We’ll show you how to replace a PCM ECM ECU Module on a 2002 Jeep Liberty. Begin replacing the Jeep PCM of your 2002 Jeep Liberty by locating the module. The location of the PCM is in the engine compartment in the back right near the battery. Before we start, make sure to do this to ensure safe replacement.
Can you replace the PCM on a 2007 Jeep Liberty?
When you’re searching for a replacement PCM, it’s important to keep in mind that PCMs are programmed for a specific make and model of vehicle. If you drive a 2007 Jeep Liberty with a 3.7-liter V6, you can’t use just any PCM. You can’t use just any Jeep PCM replacement.
Is the 3.7 liter engine in 2002 Jeep Liberty the same?
3.7 liter engine in 2002… 3.7 liter engine in 2002 Jeep Liberty, are all 3.7 liter engines the same and will work in my liberty? No not all 3.7 L are the same, there are minor internal timing gear differences and there are also set up differences for emissions and the cylinder heads are different depending on year
Its brawn is only as good as its brain, however. This is why it’s important to replace your Jeep Liberty engine control computer whenever you notice problems such as higher than normal fuel consumption, a persistent check engine light or rough automatic shifting.
If I get my friend to do it… he bleeds Jeep, and everyone that knows him, takes thier jeeps to his house to work on.. He always has a few jeeps of his own, and many part jeeps (no Libertys), and he will have my existing Jeep engine for any parts he might need, as it still runs and drives, it just has a lower end tap, so time is limited.
What kind of sensor does a 2002 Jeep Liberty need?
You will also need to put a 2002 crankshaft sensor into the 2004 engine When doing the swap use the 2002 fuel rail and injectors and swap all of the electrical sensors on the top end, MAP, TPS, KNOCK (under the intake), IAT, ETC,AND Idle air control, and any other bolt in sensor