When is the p0505 code detected?
When is the P0505 code detected? The P0505 code is set when the IACV-AAC valve does not operate properly. Engine Light ON (or Service Engine Soon Warning Light) This system automatically controls engine idle speed to a specified level.
When to use the p0505 idle air control valve?
The P0505 code is set when the IACV-AAC valve does not operate properly. P0505 NISSAN Possible Symptoms Engine Light ON (or Service Engine Soon Warning Light) Engine hard to start Rough or erratic idle speed P0505 Nissan Description This system automatically controls engine idle speed to a specified level.
When to use the p0507 code on your car?
The P0507 code is triggered when the Engine Control Module ( ECM) detects that the engine is idling higher than the specified idle rpm range. The standard engine idle is usually between 600-800rpm based on the model of the vehicle.
How much does it cost to diagnose Nissan p0505 code?
The cost of diagnosing the P0505 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0505 NISSAN code detected? The P0505 code is set when the IACV-AAC valve does not operate properly.
What causes the OBD-II code ” p0505 “?
P0505 is an OBD-II generic code that the engine control module (ECM) determined the engine idle control system is not managing the idle to stay in specification. The idle is too high or goes too low. What causes the P0505 code? The idle air control (IAC) valve is carboned up and sticks or has limited control due to the carbon build up.
How to read a malfunction code on Infiniti?
Wait two seconds, then rotate switch to full counterclockwise position. A malfunction code can be read as the long (0.6 second) blink, indicating the first digit of a two digit number and the short (0.3 second) blink, indicating the second digit.
Where is the diagnostic trouble code located on an Infiniti Q45?
On J30, M30 and Q45 models, the ECU is located behind the RH kick panel. If a malfunction occurs within the ECU/fuel injection system, a diagnostic trouble code may be stored in the ECU and the ‘‘Check Engine’’ lamp will blink. There is also a lamp built into the ECU which will concurrently blink. To read Code output, proceed as follows:
Where is the diagnostic mode switch on Infiniti?
A second, though more time consuming method of clearing Codes involves using a small screwdriver to turn the diagnostic mode selector switch, located on the side of the ECM/ECU, fully clockwise. After waiting two seconds, rotate the switch to the full counterclockwise position.