When does a 2009 Sentra die in traffic?
My 2009 Sentra has been dying when coming to stops at lights or in traffic. It has died once when in reverse in a parking spot waiting to be able to back out. I have not taken it to the shop yet.
Why does my Nissan Sentra stall after start up?
The first time, the engine stall 10 mins after start up. It was able to restart the engine, replaced the motor oil and problem seems to be fix. Now, the engine stalls 5 mins afters startup. The engine would not crank. When the key is in the ignition and on the ON position, there is a noise coming from the engine bay.
Is there a recall on the Nissan Sentra?
Please visit our recall section for this model to see if your vehicle is covered by this recall. The average cost for a Nissan Sentra General Diagnosis is between $88 -$111. Learn More
How much does a Nissan Sentra general diagnosis cost?
These sensors can fail intermittently as they warm with the engine. Sensors on certain models have been recalled by Nissan and will be replaced as necessary. Please visit our recall section for this model to see if your vehicle is covered by this recall. The average cost for a Nissan Sentra General Diagnosis is between $88 -$111.
How to remove the timing chain on a Nissan Sentra?
Timing chain tension guide The rotating direction is shown from the engine front. Disconnect battery negative terminal. Refer to PG-50, “Exploded View”. Drain engine oil. Refer to LU-8, “Draining”. Perform this step when engine is cold. Remove intake manifold. Refer to EM-27, “Exploded View”. Remove the rocker cover.
How to install front cover on Nissan Sentra?
Install front cover with the following procedure: Install valve timing control cover, if removed. Apply a continuous bead of liquid gasket (E) using suitable tool to valve timing control cover as shown. The start and end of gasket application must overlap 5 mm or more with one another.
When to fill the oil in a Nissan Sentra?
Do not fill the engine with oil for at least 30 minutes after the components are installed to allow the sealant to cure. Tighten bolts in numerical order as shown. Tighten bolt the No.1 in two step. The numerical order No.6 shows the second step.
How to tighten oil pump sprocket on Nissan Sentra?
Hold the WAF part of oil pump shaft [WAF: 10 mm (0.39 in)] (A), and then tighten the oil pump shaft sprocket bolt. Secure the oil pump shaft with the WAF part. Do not loosen the oil pump shaft sprocket bolt by tightening the oil pump drive chain. Install oil pump chain tensioner (1).