What was the ASR code on my 1995 Mercedes SL500?
The ASR system in my 1995 Mercedes SL500 has been activating for no apparent reason. My mechanic found Code 030 ASR CAN Mercedes The ASR system in my 1995 Mercedes SL500 has been…
Where is the fault code on a Mercedes SL?
The AC control unit in the R129 Mercedes SL model along with a few other MB models of the time (outlined in the CS1000 manual) could be accessed to diagnose system problems by retrieving fault codes directly from the AC control unit console in the car.
What are the ABS warning lights on a Mercedes 91 SL500?
91 SL 500 has persisting ABS ASL warning lights after an electrical fault has been repaired. Power down to 2/3. How can this be corrected? … read more Hi There, I have a Mercedes 1995 W140 S500.
What happens if you open the hardtop on a Mercedes SL500?
If either of these are open, the retractable hardtop cannot operate. Once the lid and cover are shut, the hardtop switch may be used. Start the vehicle’s engine, and let the car run while you open or close the hardtop. The hardtop does not operate if the car’s battery voltage is too low.
If either of these are open, the retractable hardtop cannot operate. Once the lid and cover are shut, the hardtop switch may be used. Start the vehicle’s engine, and let the car run while you open or close the hardtop. The hardtop does not operate if the car’s battery voltage is too low.
What kind of car is the Mercedes SL500?
The Mercedes-Benz SL500, part of the SL-Class of roadsters, is a two-door car classified as a luxury grand tourer. The SL500 comes with a variety of features, such as a retractable hardtop. This hardtop is operated by pulling up on a switch to open it, or pressing the switch down to close it. If you cannot get the
What to do if your Mercedes SL Class R129 is running rough?
Check your charging system. If your engine is running rough and misfiring you may need to change your cap, rotors and wires. If your valve cover gaskets are leaking we will show you how to replace them. Engine running lean/rough. Maybe you have a vacuum leak. If you engine is only running on one bank of cylinders you may have a bad coil.
When to replace battery in Mercedes SL Class R129?
Replace your battery if it is 5 to 7 years old. A slipping drive belt will squeal and a broken one will leave you stranded. Check your drive belt. A broken drive belt tensioner is just as bad a a broken accessory drive belt. Is your car running a little hot in traffic?
What does ABS Bas ASR light on Mercedes mean?
What do ABS BAS ASR lights mean? If any of these lights turns on and stay ON once you start to drive the car it means there is a problem with one of the following systems or related sensors. Step 1: Ensure that the main battery on your Mercedes-Benz is holding a proper charge. Mercedes-Benz cars are very sensitive to low voltage.
When does the ASR light come on on a 91 500SL?
The ASR light on my 58,000 mile ’91 500SL recently began to come on after about a mile of driving and remains on until I shut the engine down, after which it repeats next time car is driven. I notice … read more
What was the problem with the ASR on my 1992 500SL?
I started having a problem with the ASR system on a 1992 500SL. I was driving on the highway when the ASR sensor light came on and the car defaulted to a “limp home mode”: The engine output power was reduced and I was able to make almost home; after stopping at a red light the battery light came on and the car completely stalled.
What causes the ASR light to come on on a Mercedes 500SL?
Everything pointed to the Electronic Accelerator Actuator (that checked out okay as well). After discussing the past few months with the car, we established that my problem was moisture in the R25 sensor (throttle positioning sensor) causing the ASR light to come on and the engine to go into the LH mode.
The ASR system in my 1995 Mercedes SL500 has been activating for no apparent reason. My mechanic found Code 030 ASR CAN Mercedes The ASR system in my 1995 Mercedes SL500 has been…
Is there a problem with my Mercedes SL 500?
It only has 58K and is in EXCELLENT condition. On the ASR it has code 030 (no reception from EA/CC/ISC N4/1 or fault in EA/CC/ISC). My friend thinks it has a problem with the ASR computer….I was just wanting to get some second opinions from people who know Mercedes, because this ASR computer is expensive.
Everything pointed to the Electronic Accelerator Actuator (that checked out okay as well). After discussing the past few months with the car, we established that my problem was moisture in the R25 sensor (throttle positioning sensor) causing the ASR light to come on and the engine to go into the LH mode.
I started having a problem with the ASR system on a 1992 500SL. I was driving on the highway when the ASR sensor light came on and the car defaulted to a “limp home mode”: The engine output power was reduced and I was able to make almost home; after stopping at a red light the battery light came on and the car completely stalled.
It only has 58K and is in EXCELLENT condition. On the ASR it has code 030 (no reception from EA/CC/ISC N4/1 or fault in EA/CC/ISC). My friend thinks it has a problem with the ASR computer….I was just wanting to get some second opinions from people who know Mercedes, because this ASR computer is expensive.
What do ABS BAS ASR lights mean? If any of these lights turns on and stay ON once you start to drive the car it means there is a problem with one of the following systems or related sensors. Step 1: Ensure that the main battery on your Mercedes-Benz is holding a proper charge. Mercedes-Benz cars are very sensitive to low voltage.
91 SL 500 has persisting ABS ASL warning lights after an electrical fault has been repaired. Power down to 2/3. How can this be corrected? … read more Hi There, I have a Mercedes 1995 W140 S500.
Why does my SL 500 have an ASR problem?
4) The reference to M16/1r1 (usually it is M16/4r1) is due to a fault of the left EA/CC/ISC ACTUATOR (right cylinder bank). 5) There is also a reference to a Closed Throttle Position switch.
4) The reference to M16/1r1 (usually it is M16/4r1) is due to a fault of the left EA/CC/ISC ACTUATOR (right cylinder bank). 5) There is also a reference to a Closed Throttle Position switch.