What transfer case is in a 1995 Jeep Cherokee?
The NP231 transfer case is a rugged, reliable, and durable unit that has been used in a variety of vehicles since 1988. Most commonly found in Jeep Wrangler YJ, TJ, and XJ Cherokees, the NP231 is fitted with a slip-yoke style rear output from the factory.
What transfer case is in a Jeep Grand Cherokee?
The ITC (Integrated Transfer Case, MP2010) is a single-speed transfer case and it is used in Grand Cherokee’s new Quadra-Trac I Full-Time 4-Wheel Drive System.
How do I know what transfer case I have in my Jeep?
The easiest way to identify the transfer case input is by identifying the stock transmission that Jeep used. The 21 and 23 splined output shafts vary on different transmission models. The AX15 transmission is always 23 spline shaft and extends 1/2″ beyond the face of the transmission.
What transfer case does my ZJ have?
Since 1988, the NP231 has been the “Command Trac” transfer case used in the XJ Cherokee, MJ Comanche, and YJ Wrangler. It has been the “Command Trac” transfer case in the ZJ Grand Cherokee since its introduction.
What transfer case is in a 96 Cherokee?
NP249 transfer case
A: Phillip, the Quadratrac four-wheel-drive system in your ’96 Cherokee uses an NP249 transfer case. Common failures in this transfer case occur within the viscous coupler, which the case requires to transfer power while in 4-Lo.
Can you drive with bad transfer case?
Yes, you can drive with a bad transfer case.
What transfer case is in a 1996 Jeep Cherokee?
NP249
How do I know if I have a Dana transfer case?
The Dana 18, as it is commonly referred, is easily identified as it has both front and rear outputs offset to the passenger side of the Jeep. It also has 2 shifters one for high and low, the other to engage/disengage 4-wheel drive. There are 5 different varieties of the Dana 18 transfer case.
Which Jeep transfer case is best?
Top Jeep Transfer Case Swaps
- NP205.
- NP241OR.
- Advanced Adapters Atlas II.
- JB Conversions Lo-Max 205.
- Dana 300.
- Stak 4×4 Monster Box.
- Hi Impact.
- NP242.
Is it hard to replace a transfer case?
Replacing the transfer case will take a couple of hours, and it’s a heavy part. It’s important to go in knowing exactly what to do and how to do it right. We have some tips for you: To remove the driveshafts, you may want box end wrenches.