What to do when you get a trouble code on a Land Cruiser?
A 2.5 second pause occurs between codes. After a 4.5 second pause, trouble codes will be repeated. Switch ignition OFF. Remove jump lead. Carry out preparatory conditions as in normal mode. Jump DLC terminals TE2 and E1 with a short lead [1].
How long does it take for the Check Engine light to reset?
How long does it take for the check engine light to reset? If you are sure you have fixed the problem, it takes around 10-30 successful cycles before the check engine light disappears. One process is one cold-start until the engine is warm.
What’s the minimum battery voltage for a Land Cruiser?
Battery voltage 11 V minimum. Closed throttle position (CTP) switch fully closed. Transmission in neutral position. All auxiliary equipment, including air conditioning, switched OFF.
What should the valve read on a landcruiser?
It should read between 17.0-24.5 ohms. Connect the positive lead from the battery to terminal +B and negative lead to RSC, then check that the valve is closed. Fig. 1: With battery voltage applied as shown, the valve should be closed Fig. 2: The valve should open when connected as shown
How to fix sequmy 93 Landcruiser 80 series 4?
Fig. 3: The valve should close during the first sequmy 93 model landcruiser 80 – 86824p83.gif Apply ground to terminals S4, S3, S2, S1 and S4 in sequence. Check that the valve moves towards the open position. Fmy 93 model landcruiser 80 – 86824p84.gif and open during the second If the valve does not function as indicated, replace the IAC valve.
How can I tell if my Landcruiser is idle?
Using an ohmmeter, measure the resistance between terminal +B and other terminals (RSC and RSO). It should read between 17.0-24.5 ohms. Connect the positive lead from the battery to terminal +B and negative lead to RSC, then check that the valve is closed.
What should I do if my Landcruiser stops running?
Most of the time when the engine stops running, a person will need to determine if it is a fuel problem or a spark/electrical problem. Knowing which system of the truck usually helps a bunch in trouble shooting, but you maybe can by-pass that step first and go straight to the electrical problem.
What does it mean when a landcruiser starts but stalls?
Iv done alot of research and used the “search” tool for weeks but nothing has helped me out yet. After a couple of hundred bucks down the drain, im still stuck with the same issue. The truck starts no problems, or hiccups and no check engine light, and runs perfectly smooth for a whole 5-7 seconds and then stalls out.
What’s the trouble code number on a Toyota?
For example; if the check engine light blinks once and pauses followed by six blinks the trouble code number would be 16. If no code is present the check engine light will stay on constantly, to restart code gathering turn the ignition key to the “OFF” position, wait three minutes and turn the ignition key back “ON” again.
https://www.youtube.com/watch?v=kPnSa06tvqQ
Why does my Toyota Land Cruiser make a whining noise?
If your Toyota Land Cruiser is experiencing a whining noise, its is often going to be caused by something in the engine compartment. The likely cause of whining noise will be determined by when you hear the noise, and under what conditions