What to do if your Jeep Liberty has no crank?
4. Tried Neutral safety switch by moving through from Park to Neutral while turning ignition – No change. 5. Tried both keys. 6. When Key is in the “On” position.
What is the condition of my Jeep Liberty?
When the key is turned to the “Start” there is absolutely nothing. No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4.
Are there skim keys on a Jeep Liberty?
One interesting thing is that the Security LED on the dash is lit during all of this. Also, the Jeep doesn’t use the SKIM system for the keys/ignition. Mine are just the normal black (Non SKIM) keys, One interesting thing is that the Security LED on the dash is lit during all of this.
What to do when your Jeep Liberty won’t start?
When it does not start there is no crank. I have replaced the starter, Ignition switch, Ignition switch actuator pin, battery, battery cable’s, shifter cable was adjusted, small wire that goes to starter replaced that end, had the range sensor checked out! That not bad, checked relays, checked under relay box for corrosion!
When the key is turned to the “Start” there is absolutely nothing. No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4.
When did my 2012 Jeep Liberty not start?
I have a 2012 Jeep Liberty and this started close to 2 years ago now. Randomly would not start every once in a while (it would crank but not start). Went to goodyear, they replaced my throttle body, did a bunch of other work (close to $1,000) and then 6 months later it started again.
What causes a jeep to have no start?
Most Chrysler and Jeep no start problems can be traced to the following items: • Auto Shutdown Relay (fails to provide power to the powertrain control module) • Transmission Range selector (PCM must see park or neutral before it will allow start)
Why does my Jeep Liberty engine not start?
There are a lot of issues that can cause your Liberty to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
What happens when a Liberty starter goes bad?
When a starter goes bad, they will usually not give you much warning first. Also, if you are stuck somewhere and are trying to start your Liberty, the old beat the starter with a hammer trick is not a wives tale. It really can get that one last start out of it. There are a lot of issues that can cause your Liberty to crank, but not start.