What size rear end is in a S10?
According to Chevy High Performance, the 7.5-inch was standard until 1993, when the previously optional 7.625-inch became standard. 1995 and newer S-trucks equipped with the high-output V6 were equipped with the 8.5-inch rear end.
How wide is a S10 zr2 rear end?
spring perches are the same, the regular 4x rear end should be a 7.5″ with a WMS width of 59″, while the zr2 should be a disked 8.5″ with a WMS width of just under 63″. Thanks for the help! That helps.
How wide is a Chevy 10 bolt rear end?
The rear end on a chevy 10 bolt measures 10-15/16-inches wide by 10-5/8-inches tall.
What rear end is in a 91 S10?
the stock rear end is a 28 spline 7.5″ 82-93 have a 26 spline.
How do I identify a GM 10 Bolt differential?
The casting numbers for 10-bolt rear differentials are typically located either on the forward side of the passenger-side axle tube or on the driver’s side. These numbers are approximately 3 inches from the center section.
How do I identify a 10 bolt rear end?
The easiest way to identify the 8.2-inch rearend at a glance is by the shape of the housing and the spacing between the lower bolts on the cover. The 8.2-inch 10-bolt has a smooth, round, lower-case area (no cast-in protrusions), with an 11-inch cover that has a diagonal protrusion at the top.
Which is the best rear end for a S10?
The S10 10bolt 7.5/7.625″ rear end is a good choice for the light low to medium horsepower small block cars. If you’re running a blower, turbo, nitrous, etc you will probably want to step up to a larger rear like a 9″ or 12 bolt. Its pretty easy to find a good one if you are in an area with a few junkyards.
What was the rear differential on the Chevy S-10?
by Floyd Drake III. The Chevrolet S-10 pickup truck, one of the first compact models manufactured by a domestic auto maker, was equipped with three different rear-differentials, or rear ends. According to Chevy High Performance, the 7.5-inch was standard until 1993, when the previously optional 7.625-inch became standard.
How big is the shaft on a S10?
According to S10 Planet, the 7.5-inch shaft has 26 splines, or grooves, while the 7.625 has 28 splines. A native of New Haven, Conn., Floyd Drake III began writing in 1984. His work has appeared in the “New Haven Register,” Medford’s “Mail-Tribune” and the “Ashland Daily Tidings.”
What kind of bearing does a S-10 pinion use?
The S-10 pinion gear requires Timken bearing #16143, Timken bearing race #16283, and National seal #8610, S-10 pinion yoke, and “Combination” U-joint (Dana #5-3022X). As with most all gear sets a specific gear carrier is required for a specific range of gear sizes, so the carrier must be the correct series for the gear set that you want.