What size is the axle nut on a Jeep Cherokee?
36mm
Then remove the nut using a 36mm socket. Use a large screwdriver in your brake rotor to keep everything from spinning. Use a breaker bar to free the axle nut.
What size is the axle nut on a 95 Jeep Grand Cherokee?
it is a 36 mm.
What size is the axle nut on a 2000 Jeep Grand Cherokee?
Registered. No, the axle nut is a 6 point 36mm. The hub bolts use a 12 point 13mm.
How big should axle nut be on Jeep Cherokee?
I also tend to use never-seez on the unit bearing retainer screws – then torque them to 37-38 pound-feet, vice the “clean, dry” spec of 75 pound-feet (so I can take those damned things off later if I need to as well!) Remember, if the FSM value doesn’t list a lubricant as required, it’s a “clean, dry” spec.
How to replace front wheel bearing on Jeep Grand Cherokee?
Have yr. 2000, 4.7 L, Grand Cherokee. Looking for step-by-step instructions for replacing front wheel bearing. ah, its a piece of cake. Jack up the vehicle, remove the wheel and ofcourse use a jack stand. I do one side at a time because it might take a lot of torq to get the hub bolts loose. Take off the caliper and brakes.
How do you remove the knuckle on a Jeep Cherokee?
remove the 3 bolts that hold the knuckle on (1/2 12pt). take a hammer and hit around the inside of hub until it comes off. Once it is off take some sand paper and clean up the rust where the hub and knuckle push together. On my Jeep I have aftermarket wheels so I am able to access the main hub nut with the wheel still on.
Can a hub nut still be used on a jeep?
On my Jeep I have aftermarket wheels so I am able to access the main hub nut with the wheel still on. With the nut torqued to 175ft/lbs and rust/dirt seizing up the nut, it isn’t a surprise that a cheater bar helps In this case it is my old tie rod.
I also tend to use never-seez on the unit bearing retainer screws – then torque them to 37-38 pound-feet, vice the “clean, dry” spec of 75 pound-feet (so I can take those damned things off later if I need to as well!) Remember, if the FSM value doesn’t list a lubricant as required, it’s a “clean, dry” spec.
How big is the nut for the CV joint?
Want to make sure I have the right size long socket for the hub nut for the cv joint. I drive an ‘08 Yukon Denali; I’m sure all are the same, but just in case. I’ve ordered ACDelco replacement HUB and knockoff axle since I’ve heard the hub should be OEM—if possible—but the axle isn’t as critical in terms of OEM quality.
How big is the hub nut on a Chevy Tahoe?
Discussion in ‘ Engine & Drivetrain ‘ started by Mr T, Jan 19, 2019 . Doing a left front Hub replacement. Want to make sure I have the right size long socket for the hub nut for the cv joint.
How big is the CV axle nut on a Yukon Denali?
I drive an ‘08 Yukon Denali; I’m sure all are the same, but just in case. I’ve ordered ACDelco replacement HUB and knockoff axle since I’ve heard the hub should be OEM—if possible—but the axle isn’t as critical in terms of OEM quality. Thanks! I believe it’s 35mm. I’d have to check out in the garage to make sure, but it’s either 35mm or 36mm