What kind of SRS light does a C240 have?

My car is a 2001 w203 C240 4matic with 62,000 km (I almost never use this car) last mont the car show me in the dash board the message SRS malfunction and the red SRS light turn on, so I bought an i980… Unfortunately, that’s the most I can help with this problem.

Where are the transmission codes stored in a Mercedes?

Specific codes related to the transmission are stored in the TCU (Transmission Control Unit) and come generic codes such as P0705 are stored in ECU (Engine Control Unit). You don’t need to pay anyone to read the codes; you can retrieve them yourself in a couple of minutes with the right OBD II scanner.

How to troubleshoot your Mercedes Benz air conditioner?

Identify the location of your compressor. Look at the pullyer and you should be able to see if it spining or not. The engine running turn the A/C on max cool, set fans high, and make sure that the clutch is engaging on the compressor. The pulley spins any time the engine is running. The center part of the A/C pulley only engages when the A/C is on.

Why is my Mercedes-Benz C240 not working?

What are common reasons my Mercedes-Benz C240 has air conditioning problems? While there are a variety of reasons your Mercedes-Benz C240 air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.

Why does my C240 make a clicking noise?

Find the most common driver-reported problems that are to blame when a Mercedes-Benz C240 has air conditioning problems. Broken Stepper Motor Actuating Arm May Cause Cl… A repetitive clicking noise from behind the center area of the dash panel is usually caused by a broken stepper motor… Broken Stepper Motor Actuating Arm May Cause Cl…

Why is my a / C not working in my car?

Learn if it’s a simple fix or time to seek out a trusted technician. Not your vehicle? Why Isn’t My A/C Working? What are common reasons my Mercedes-Benz C240 has air conditioning problems?

How to replace seat sensor on Mercedes SRS?

Tip the seat top down and remove the complete car seat from the car. 11. Remove the connector block and unplug the yellow sensor (PIC 13 ) connector from it’s housing under the seat. 12.Take off the plastic side covers. 13. Loosen the 2 back bolts, (PIC 14-15 ) and remove the 2 front ones, This is optional and done to make the job easier. 14.

Is there a child seat recognition sensor on Mercedes Benz?

This sensor is found not only on Mercedes-Benz E-Class W211 or S-Class W220 but also on other models such as CLS, CLK-Class, C-Class, ML-Class. Most Mercedes-Benz models since 2000 have the child seat recognition sensor installed. This is a great safety feature, but it does fail quite frequently.

Which is the best diagnostic scanner for Mercedes Benz?

One of the best scanners that you can use to troubleshot your Mercedes-Benz is the Launch Creader Diagnostic Scanner which you can find on Amazon. It is affordable for Mercedes-Benz owners to do troubleshooting on their cars. Not does it work on Mercedes-Benz cars, but it also works on European, Asian and Domestic cars.

What does the SRS light mean on a Mercedes Benz?

What does SRS light mean? SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system.

Is there a scanner that reads the SRS light?

Here is a scanner that works with Mercedes-Benz and will rear fault codes and reset the AirBag, ABS and check engine light. Our favorite scanner that for an in-depth Mercedes-Benz troubleshooting is the iCarsoft MB II. Not only does it read the SRS light (Airbag Control Unit) but also every control unit in your Mercedes-Benz.

What does it mean when SRS warning light stays on?

SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. It is very unlikely that your airbags are going to deploy randomly, but the concern is that they may not deploy…

How do you reset SRS on a Mercedes Benz?

Turning the steering wheel fully left and right doesn’t reset SRS – it re calibrates the steering angle sensor. If you disconnect the vehicle battery, you will need to do this if the ESP error light is illuminated. Start the engine and then run the steering through its full left and right range. That will extinguish the ESP light.

How can I Reset my SRS warning light?

It will tell you where the problem is and allow you to reset it once the problem is fixed. Our favorite scanner that will read and reset your SRS / airbag light is the iCarsoft i980 for Mercedes-Benz which will retrieve the SRS light but also the check engine.

Where is the SRS fault on the Mercedes E class?

Here is a way to deal with a common SRS fault that lies within the seat pad of the Mercedes E Class (W210). (I am sure also similar for other models)

How often does Mercedes W210 SRS need to be serviced?

The service history of my current E Class W210 shows repeat visits over 10 years for this specific SRS problem and I would like to share with you the ins and outs of it all (each visit cost the previous owner £220 for the cure/pleasure – only to have it return again almost every 18 months to 2 years during ownership)

Why is the SRS warning staying on on a Mercedes Benz?

Why is the SRS warning staying on? Here is a list of some of the most common problems with the SRS system on a Mercedes Benz. Seat Occupancy Senor in the passenger seat. Low voltage in the electrical system. Battery issue or charging. Seat belt latch. Damaged Wire Contacts at the doors. Defective, damaged or loose contact at the impact sensors.

Here is a way to deal with a common SRS fault that lies within the seat pad of the Mercedes E Class (W210). (I am sure also similar for other models)

Why does my SRS light keep going on?

Very often the SRS/Airbag light goes on mainly because of a dying battery. But, if the light is on, it will stay on when you install a new battery, until you manually reset it. That is, 2 steps to solve SRS/Airbag light on. Step 1 Install a new battery; Step 2 Reset SRS/ Airbag light. Instruction on How to Reset the SRS Light on a Mercedes Benz: 1.

What are the fault codes for Mercedes SRS?

Child seat:”Signal” transmission fault between front passenger seat and “Babysafe” Part E2e5 (Turn signal lamp) in module E2 (Right front headlamp unit) is defective. C1011. BAS light, play in steering column causes steering angle sensor to lose memory (?) C1401.

What do the lights on the Mercedes dashboard mean?

Modern Mercedes-Benz cars are filled with lots of sensors that monitor how each system in the car is behaving. The lights on the dashboard display what systems are in use and they also highlight when one of those systems is not working as it should. But what do all those different symbols mean?

What are the warning lights on a Mercedes Benz?

The following are warning lights and indicators found in vehicles built by Mercedes Benz. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 40 of them so be patient!

When does the SRS airbag warning light come on?

Low voltage – SRS airbag light can be triggered when you jump-start a dead car battery. Previous accident – Even a small accident may be recorded in the SRS module triggering the airbag light to come on.

Where is the reset SRS light on a Mercedes Benz?

Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it. This is located on the lower left side of the control panel on the driver’s side of the car.

Can You reprogram an SRS airbag module?

You can choose to reprogram your SRS airbag module yourself. Or, you can turn to the company Safety Restore to do the work for you. That way, you can rest assured that the unit is in knowledgeable hands, and the repairs will be properly completed.

How to read and reset SRS / airbag light?

Battery dying. How to read and reset SRS/ Airbag light? Very often the SRS/Airbag light goes on mainly because of a dying battery. But, if the light is on, it will stay on when you install a new battery, until you manually reset it. That is, 2 steps to solve SRS/Airbag light on. Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it.

Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it. This is located on the lower left side of the control panel on the driver’s side of the car.

How to replace the SRS seat pad light?

1. At some point, have the codes read, by an inde, (PIC 1 ) as having the seat pad SRS light on will ‘MASK’ other ( emergency tensioning retractor belt and bag) faults. 2. Buy a NEW sensor first, (PIC 2 ) I have not seen ANY signs of wear ( wires, scraping, breaks ) at all. The sensor ‘dots’ fail with use/age. Sensors cost 140 US$ at MB. 3.

How does the SRS seat belt system work?

A; Many.. The SRS system has a pre-tensioner in each seat belt, several air bags, sensors throughout the car to activate same, and a child sensor in the front passenger seat. A; The child sensor adjusts air bag and seat belt level for the front passenger, and effects the functionality of several other devices.

Navigation