What kind of actuator does a Honda Pilot use?
We offer a full selection of genuine Honda Pilot Blend Door Actuators, engineered specifically to restore factory performance. Please narrow the Air Blend Door Actuator results by selecting the vehicle.
How does an air blend door actuator work?
An air blend door actuator is constructed from a plastic housing, a small electric motor and a plastic gear set. A door position sensor is also incorporate into the unit to send feed back information to the climate control computer.
How can I tell if my blend door actuator is bad?
To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level. Compare the bad actuator to the new unit.
How to replace driver door lock actuator on Honda Accord 2?
The complete procedure for this can be found here: Removal of driver door panel on the 2003-2007 Honda Accord 2. Peel back the waterproof covering. Note the methods mentioned in the previous post on how to do this successfully without tearing the stuff. You only need to peel back the rear portion, enough to allow free access to the needed parts.
How do you replace the lock actuator on a car?
Just unhook and slide through the holes on the metal. The lock actuator is behind this screw. 5. Remove this plastic tab securing the cable to the interior driver door handle. You will need to do this by feel. Slip your hand behind, pinch and push the other ends of the plastic to come through the hole.
How to change the actuator on a Honda Pilot?
Gently open the white plastic sheet about a quarter of the way from the top right down so you can reach in the actuator area (near the door latch – at the end of door with 3 screws). Open the window guardrail, if its in the way – use a 3/8 bolt. 7. Use correct amount of force, without stripping them, open the 3 screws at the door latch. 8.
How much does it cost to replace Honda door lock actuator?
The average cost for a Honda Pilot door lock actuator replacement is between $177 and $240. Labor costs are estimated between $88 and $111 while parts are priced between $89 and $129. Estimate does not include taxes and fees.
How to replace the door lock on a Honda Pilot?
1. Remove the plastic tab under the inner door latch. 2. Open the 2 small black colored screws. 3. Carefully swing the door latch attachment out by moving it down and out. Remove the rod and the electrical connection – there’s a slot to press and pull-out.
How does the power door lock actuator work?
Vehicles equipped with power door locks have a power door lock actuator in each door. The door lock actuator is an electronically controlled motor that automatically locks, or unlocks a door, trunk or rear hatch when the driver or passenger pushes a lock/unlock button on any door panel or remote. How does the power door lock actuator work?