What is the second half of a fuel pump relay?
The second half of the relay is the “switch” that controls power to a particular accessory; like a fuel pump. Terminals 86 and 85 are the primary side of the relay. It utilizes an electromagnet to close (connect) the secondary electrical circuit inside the relay.
What to do if your fuel pump relay stops working?
Connect one lead to one of the power circuit pins, and connect the other lead to the other power terminal. If you hear a beeping sound, your fuel pump relay’s power pins have shorted. Replace the relay. You can test the fuel pump relay, along with many other parts in your car, with the cheap and handy multimeter. (Photo Source: carcody)
Is the fuel pump relay controlled by the PCM?
Consequently, the fuel pump relay is usually controlled by, the ignition or powertrain control module (PCM). As a result, when switched on, the fuel pump relay; will provide current to the fuel pump, so that it may function. Therefore, any faults with it, can cause fuel pump issues.
How much does it cost to replace a fuel pump relay?
You can easily find fuel pump relays online or at any automotive spare parts shop.The average replacement cost of the fuel pump relay ranges from $90 to $150, of which $20-$50 is for parts and the remaining is the labour cost.
The second half of the relay is the “switch” that controls power to a particular accessory; like a fuel pump. Terminals 86 and 85 are the primary side of the relay. It utilizes an electromagnet to close (connect) the secondary electrical circuit inside the relay.
How to test a suspect fuel pump relay?
1 The easiest way to test a suspect fuel pump relay is to; swap the suspect relay with a good one. 2 You may find another relay in your car with the same configuration as your fuel pump relay. Just make sure the other relay has the same configuration. 3 Remove the suspect relay and install the good relay and check if your engine fires up.
Where do I put the Kill Switch on my car?
To install this on your car, you will need to go under the car and find the fuel line.
How do you wire an ignition kill switch?
By using a wiring diagram for your car, you should be able to find which wire is your ignition cable and determine the proper one to cut into. Once the wire is cut, you can either solder the 2 ends of the wire into the switch, or use additional connectors and crimp it on (no soldering required). Below is an ignition kill switch wiring diagram:
What to do if your fuel pump relay fails?
Pull out the relay and visually inspect the terminals and socket; for signs of corrosion and overheating. Because, corrosion and overheating can prevent, proper current flow and indicates problems. Clean corroded terminals and socket with, electrical contact cleaner. Next, check all fuses before any repairs.
What does a test light on a fuel pump do?
Consequently, It acts as the “switch” that connects electrical current, from one terminal to the other. Use Jumper wires to supply 12v power to terminals 86 and 85. Next, use a test light on terminals 87 and 30, to see if you have power. Finally, if the test light goes on the the problem lies somewhere else.
https://www.youtube.com/watch?v=B8yefTe5thk