What is Mazda high beam control?
HBC（High-Beam Control） High Beam Control (HBC) detects oncoming and preceding vehicles and automatically switches between high and low beams during night driving, making it easier for the driver to recognize hazards. The system helps the driver drive with peace of mind at night.
What is the high beam control system on a Mazda 3?
Mazda 3 Owners Manual: High Beam Control System (HBC) The High Beam Control System (HBC) determines the conditions in front of the vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch the headlights between high and low beams.
How do you adjust the headlights on a Mazda 3?
You can adjust the headlights on your Mazda 3 by using the 10mm adjustment bolt on the backside of the headlight housing assembly. This bolt will allow the only adjustment available on the Mazda 3.
Where is the adjustment bolt on a Mazda 3?
Open the hood of the car and locate the adjustment bolt on the back of the headlight housing assembly. Turn the headlight adjustment bolt until the headlight beam shines at the base of the wall or other flat surface near the ground. Ideally, you want the headlights to shine where the headlight beam meets the ground.
How do you turn on high beam control?
If you don’t think that the High Beam Control is already working, thankfully turning the system back on is quick and easy. Here’s how: Start by turning the headlight switch to AUTO. Then, push the headlight lever forward. This will place it in the high beam position.
How do you adjust the headlight beams on a Mazda 3?
Tire pressure is at specification. The reflectors for the low and high beams are an integrated unit. Therefore, perform the headlight aiming adjustment on only the low beam. 1. Point the headlight beams to a wall and verify that the headlight beams are as shown in the figure.
Mazda 3 Owners Manual: High Beam Control System (HBC) The High Beam Control System (HBC) determines the conditions in front of the vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch the headlights between high and low beams.
Open the hood of the car and locate the adjustment bolt on the back of the headlight housing assembly. Turn the headlight adjustment bolt until the headlight beam shines at the base of the wall or other flat surface near the ground. Ideally, you want the headlights to shine where the headlight beam meets the ground.
Can you adjust the headlight aiming with cargo?
If the headlight aiming is adjusted with cargo in the vehicle, it may not adjust correctly. Adjust the headlight aiming with the vehicle under the following conditions: Tire pressure is at specification. The reflectors for the low and high beams are an integrated unit. Therefore, perform the headlight aiming adjustment on only the low beam. 1.