What is a consult 2?
Consult-II. The Nissan ® Consult-II ® scan tester is a multi-function scan tester for worldwide Nissan ® Dealers. It replaced the Consult as the premier, essential tool for computerized on-board systems of Nissan ® and Infiniti ® vehicles.
What is the hex code on Nissan X Trail?
208 readout fault codes on NISSAN X-TRAIL OBD Code P0089, Hex Code 0089, Decimal Code 137 ( 34 times read) ECU Diagnostic System (EOBD/OBDII) (43 times read)
Is the Nissan X Trail difficult to start?
X-trail 2.2 dci, Difficult to start from cold, engine hunts on tick over for a short while. Car runs fine when cold and Nissan/Datsun x-trail x-trail 2.2 dci, Difficult to start… Nissan x-trail 2005.
How to put Nissan engine in diagnostic mode?
There are three methods of putting vehicles with this connector into diagnostic mode. If one does not work, try the others. Select one of the methods below. This is the prefered method. To select this method click ‘Connector Method’. Does not require a connector. To select this method click ‘Pedal Method’.
Where do I find the trouble code on my Nissan?
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
208 readout fault codes on NISSAN X-TRAIL OBD Code P0089, Hex Code 0089, Decimal Code 137 ( 34 times read) ECU Diagnostic System (EOBD/OBDII) (43 times read)
What is the diagnostic code for a Nissan?
Nissan Diagnostic Fault Codes List. Nissan Logo. P0100 Airflow Circuit Malfunction. P0101 Wrong indicator / air flow meter not adjusted. P0102 Low air mass meter reading. P0103 High air mass meter reading. P0104 Malfunction of the air mass meter.
Can a Nissan X Trail be repaired with autoaid?
With autoaid you repair your NISSAN X-TRAIL quick and easy at low cost. Our experts and the autoaid diagnostic tools assist you in finding the cause of error and support you with all questions for repair with the best solution.
How to clear engine codes without a Nissan consult or scan tool?
How to clear the engine codes without a Nissan CONSULT or scan tool. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Fully depress the accelerator pedal and keep it for more than 10 seconds. The emission-related diagnostic information has been erased from the backup memory in the ECM.