What happens when O2 sensor is replaced but not fixed?
AFR sensor output shifted to lean and ECM was fooled and injected more fuel. That’s why O2 sensor stuck rich. After replaced AFR sensor, CEL/VSC/4WD lights were gone and fuel trim%, AFR, O2 data is in normal range.
What should I do if my steering angle sensor has failed?
If the harness is plugged in and has not moisture on it, then the sensor has probably failed. You can have the vehicle realigned, but if the sensor has failed, it will not correct its self. I recommend replacing the steering angle sensor.
Why is the proximity sensor not working after a screen replacement?
After installing the screen, proximity is not working. Okay little annoyed at this point, instinctively I assume the flex cable is seated improperly. Re-seat the cable and still unresponsive. As the frustration builds, I think maybe there’s something wrong with the alignment of the proximity sensor and the small hole on the back of the bezel.
What to do if ABS wheel speed sensor goes out?
If the ABS wheel speed sensor was faulty, once the new hub/sensor is installed, and you drive the vehicle, the warning lights should go out. To determine what is going on, you can manually erase the trouble codes using an appropriate scan tool and if the warning lights stay off, then the problem is resolved.
Is it possible to repair a motion sensor light?
Sometimes, the easiest repairs can solve major problems. If it seems like the motion sensor light has given up the ghost, then you should try cleaning the sensor first, and then remove the old bulb from the light and insert a new one.
What happens if I don’t replace the knock sensor?
The knock sensor on the engine is there to detect for an engine noise from pre ignition (pining) normally. This is so the computer can advance the ignition timing to the maximum it can without the engine pinging. This gives you the best engine power and fuel mileage.
Why is my proximity sensor not working after a screen replacement?
In screen replacement , always I used front camera and sensors and home button from the old display. Although everything work properly on old display, after replacement in most of the times proximity sensor is not working.
What should I do after replacing my NoX sensor?
After you’ve soldered and applied heat to your newly repaired device, you should leave it for several minutes to reach a normal temperature. Now that you’ve replaced the probe on your NOx sensor, this should be the end of your diagnostic issues!